User manual HOTPOINT-ARISTON AQXL 145

[. . . ] This symbol guides you step by step in operating the unit. 2. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentally-responsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". Printed on recycled paper. [. . . ] load quantity (dry weight) 5kg SPIN (SCHLEUDERN) 2. 5kg 2. 5kg 2kg 1kg SHORT SPIN (SCHONSCHLEUDERN) Programme selector 30 Instructions for use Cleaning and Care Control Panel Attention!For cleaning panels and control parts, do not use furniture polish or any aggressive cleaning agents. Wipe off control panels with a damp cloth. Use warm water to do this. 0 Washing Detergent Drawer The washing detergent drawer should be cleaned from time to time. Pull out the washing detergent drawer as far as it will go. Remove the washing detergent drawer with a firm pull. Remove the softener insert from the middle compartment. Clean the softener insert under running water. 5. Clean the compartments from the rear with warm water. Push on the softener insert as far as it will go so that it is secure. 31 Instructions for use 7. Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Cancel child safety system (see section on "Child Safety System"). Turn on the water tap. Turn off the water tap. UnFilter in screw connection of screw the hose from the tap, the inlet hose is blocked. remove the filter and clean under running water. Water tap is defective or blocked by limescale. Check water tap, have it repaired if necessary. 34 Instructions for use Problem Possible Cause Remedy Remove transport packaging in accordance with the installation and connection instructions. Adjust in accordance with the installation and connection instructions. The transport packaging has not been removed. The height-adjustable screw feet are wrongly positioned. The washing machine vibrates during operation or is unstable. There is very little washing in This does not impair the the drum (e. g. The water could not be completely pumped out before spinning because the drain hose is kinked or the drain pump is blocked. Check the drain hose and remove any kinks if necessary, or clean the drain pump and, if required, remove foreign bodies from the pump housing. It may be necessary to reduce the amount of Excessive foaming dur- Probably too much detergent detergent used. detergent manufacturer's recommendations. [. . . ] Otherwise the repelling power of the draining water can press the hose out of the sink. Fix the elbow to the water tap or to the wall with string. 0 53 Setting up and connection instructions Delivery Heads over 1m To pump off the washing / rinsing agent, every washing machine has a pump which transports liquids via the drainage hose up to a height of 1m, calculated from the machine's floor. For delivery heads over 1m, consult the Customer Service. Technical Data Height adjustment Filling quantity (program-dependent) Use Drum speed, spin Water pressure Approx. 5kg Domestic see rating plate 1-10bar (=10­100N/cm2 = 0. 1­1. 0MPa) Dimensions (Measurements in mm) 54 Customer Services Customer Services Schweiz - Suisse - Svizzera A + T Hausgeräte AG Kundendienst AEG Industriestraße 10 5506 Mägenwil Service Eine Tel. -Nr. [. . . ]