User manual HOTPOINT-ARISTON AVTXF 149

[. . . ] General safety, 21 Disposal, 21 Saving energy and respecting the environment, 21 Cutting off the water or electricity supply, 22 Cleaning your appliance, 22 Caring for your appliance door and drum, 10 Cleaning the pump, 22 Checking the water inlet hose, 22 Cleaning the detergent dispenser, 22 Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washing machine to inform the new owner as to its operation and features. Keep this instruction manual in a safe place for Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine. Putting your appliance in place and moving it. [. . . ] Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, remains fixed. After approximately 2 seconds the setting is accepted: the symbol The temperature adjustment is enabled with all wash programmes. Press the button and you will see the word OFF on the display, while the relative symbol flashes. Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the "desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the set remains on. Programme appears on the display and the symbol If you now press the START/RESET button, the set "delay" appears; this decreases every hour until the start of the cycle. In this phase, the "delay" can only be modified by decreasing it. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled. Good washing results also depend on the correct dose of detergent: adding too much detergent won't necessarily make for a more efficient wash, and may in fact cause build up on the interior of your appliance and even pollute the environment. open up the detergent dispenser and pour in the detergent and fabric softener , as follows. Compartment 1: Detergent for pre-wash compartment 2: Detergent for the wash cycle (powder or liquid) It is recommended that you place liquid detergent directly into the compartment using the appropriate dosing cup. The softener is added automatically into the machine during the last wash. At the end of the wash programme, some water will be left in compartment 3. This is used for the inlet of denser fabric softeners into the machine, i. Should more than a normal amount of water remain in compartment 3, this means the emptying device is blocked. Divide your laundry according to: - the type of fabric/the symbol on the label. - the colours: separate coloured garments from whites. Empty all pockets and check for loose buttons. Do not exceed the weight limits stated below, which refer to the weight when dry: Sturdy fabrics: max 6 kg Synthetic fabrics: max 2. 5 kg Delicate fabrics: max 2 kg Wool: max 1 kg How much does your laundry weigh?Wash them separately without exceeding half the appliance load. Use programme 11 which excludes the spin cycle automatically. Quilted coats and windbreakers: if they are padded with goose or duck down, they can be machine-washed. [. . . ] 4) have been pulled out, check whether the same are not clogged and then rinse them. Reassembly: Do not forget to reinsert the pair of siphons into the special housings and then to replace the dispenser into its seat, clicking it into place (fig. Your washing machine could fail to work. Before calling for Assistance (see page 24), make sure the problem can't easily be solved by consulting the following list. [. . . ]