User manual HOTPOINT-ARISTON HB6116

[. . . ] Connect the end of the water inlet hose to the washing machine, screwing it onto the appliance's cold water inlet, situated on the top right-hand side on the rear of the appliance (see figure). Once the washing machine has been removed from the packaging, check that it has not been damaged during transportation. If it has been damaged, contact the retailer and do not proceed any further with the installation process. Remove the 4 transit bolts used during transportation and the corresponding spacers on the back of the machine (see figure). [. . . ] Turn the PROGRAMME KNOB left or right, until the required programme has been selected; the name of the programme will appear on the display. A temperature and spin speed is set for each programme; these may be adjusted. The machine automatically selects the temperature and the maximum spin speed for the programme set and these values may not be button, the tempeincreased. By pressing the rature can be progressively reduced or even set to button, the cold wash OFF. by pressing the spin speed can be progressively reduced or even eliminated altogether OFF. If the buttons are pressed again the maximum values are restored. Press the button to activate the option; the name of the option will then appear on the display and the corresponding indicator light will illuminate. Press the button again to deactivate the option; the name of the option will then appear on the display followed by the text OFF, and the corresponding indicator light will switch off. If the selected option is not compatible with the Set programme, the indicator light will flash and the option will not be activated. If the selected option is not compatible with another option that has been selected previously, the indicator light corresponding to the first option selected will flash and only the second option will be activated; the indicator light corresponding to the active option will remain lit in a constant manner. The options may affect the recommended load The corresponding indicator light remains lit in a fixed manner and the porthole door locks (the DOOR LOCKED indicator light illuminates). This option is not compatible with the Wool, Fast spin ), its colour, the temperature of the wash, the level of soiling and the hardness of the water in the area. Measuring out the detergent carefully will avoid accidental spills and help to protect the environment: although they may be biodegradable, detergents contain elements that alter the balance of nature. We recommend: the use of powder detergents for white cotton garments and for pre-wash phases; the use of liquid detergents for delicate cotton garments and for all programmes which run at a low temperature; the use of liquid detergents for wool and silk. Do not use detergents when washing garments by hand, because they create too much foam. The detergent must be measured out into the relevant compartment, or into the detergent dosing ball which will be placed directly into the drum of the machine. In this case the Cotton cycle with pre-wash phase may not be selected. 0508) from The Woolmark Company, which certifies the machine washing of all woollen garments, even those whose label states hand . The Wool programme therefore offers wash only you complete peace of mind when washing all woollen garments, with great performance guaranteed every time. Duvets: to wash double or single duvets (the weight of which should not exceed 3 kg), cushions or clothes padded with goose down such as puffa jackets, use the special "Duvets" programme. We recommend that duvets are placed in the drum with their edges folded inwards (see figure) and that no more than ¾ of the total volume of the drum is used. To achieve the best results, we recommend that a liquid detergent is used in conjunction with the detergent dispenser drawer. [. . . ] Make sure that the wash cycle has finished and From time to time your machine may not operate as it should. Before calling for Assistance (see Assistance), make sure that the problem cannot be resolved easily using the following list. The plug has not been inserted into the electrical socket, or it has not been inserted far enough to make contact. The porthole door has not been shut properly. [. . . ]