User manual HOTPOINT-ARISTON HB6510

[. . . ] You will find the guarantee and other details relating to Before connecting the inlet hose to the water supply, allow the water to flow from the tap until it runs clear. Connect the inlet hose to the machine, by screwing it into the cold water inlet on the upper right hand side of the back of the machine (see figure). Once the washer-dryer has been removed from the packaging, check that it has not been damaged during transportation. If it has been damaged, contact the retailer and do not proceed any further with the installation process. [. . . ] For advice as to the type of detergent to use for button. Turn the PROGRAMME KNOB left or right, until the required programme has been selected; the name of the programme will appear on the display. A temperature and spin speed is set for each programme; these may be adjusted. The machine automatically selects the temperature and the maximum spin speed for the programme set and these values may not be button, the tempeincreased. By pressing the rature can be progressively reduced or even set to button, the cold wash OFF. by pressing the spin speed can be progressively reduced or even eliminated altogether OFF. If the buttons are pressed again the maximum values are restored. Press the button to activate the option; the name of the option will then appear on the display and the corresponding indicator light will illuminate. Press the button again to deactivate the option; the name of the option will then appear on the display followed by the text OFF, and the corresponding indicator light will switch off. If the selected option is not compatible with the Set programme, the indicator light will flash and the option will not be activated. If the selected option is not compatible with another option that has been selected previously, the indicator light corresponding to the first option selected will flash and only the second option will be activated; the indicator light corresponding to the active option will remain lit in a constant manner. If your laundry load to wash and dry is exceptionally in excess of the maximum load foreseen (see table of drying times), perform the wash cycle, and when the programme is complete, divide up the garments and put part of them back in the drum. Now follow the instructions provided for a Dry only cycle. : a cooling-down period is always added to the end of each drying cycle. ), its colour, the temperature of the wash, the level of soiling and the hardness of the water in the area. Measuring out the detergent carefully will avoid accidental spills and help to protect the environment: although they may be biodegradable, detergents contain elements that alter the balance of nature. We recommend: the use of powder detergents for white cotton garments and for pre-wash phases; the use of liquid detergents for delicate cotton garments and for all programmes which run at a low temperature; the use of liquid detergents for wool and silk. Curtains: these should be folded and placed inside the bag provided. 0508) from The Woolmark Company, which certifies the machine washing of all woollen garments, even those whose . The Wool label states hand wash only programme therefore offers you complete peace of mind when washing all woollen garments, with great performance guaranteed every time. Bathroom laundry and bedlinen: this washerdryer can be used to wash any domestic laundry in a single cycle called BED&BATH 7 DAYS that optimises the use of fabric softener while saving both time and electricity. we recommend that you use a powder detergent. [. . . ] ) fall into the pre-chamber that protects the pump (the pump is located in the lower part of this prechamber). Make sure that the wash cycle has finished and From time to time your machine may not operate as it should. Before calling for Assistance (see Assistance), make sure that the problem cannot be resolved easily using the following list. The plug has not been inserted into the electrical socket, or it has not been inserted far enough to make contact. [. . . ]