User manual HOTPOINT-ARISTON HB8350

[. . . ] The spanner is for illustration only and is not supplied with the fridge. USEFUL ADVICE STEP 5 After the front feet have been adjusted and the fridge is level, fit the left and right hand bottom hinge covers supplied. Align with the cover plate slots and push into position. STEP 6 Before plugging in and switching on, leave the fridge in its final location for at least 15 minutes to allow it to settle. CLEANING & MAINTENANCE TROUBLESHOOTING STEP 7 Plug in and switch on. Allow the fridge to cool before placing food inside. All food in the fridge should be covered. STEP 8 Your fridge is now working. [. . . ] The lidded commodity rack is recommended for the storage of dairy items, such as butter, margarine and cheese. To remove, lift rack vertically to release from fixing supports. To replace, align grooves on either side of the rack above fixing supports and push down until secure. In order to get the best results from the bottle retainer it is advised that it be positioned centrally on the bottle rack. Egg Rack The egg rack can be used in conjunction with any commodity rack and is easily removed for cleaning. Note: Wipe, don't wash eggs. USEFUL ADVICE Advice on Adjusting Shelves Make the most of the interior storage space by repositioning shelves to suit the various heights of individual items you wish to store. To remove, ensure that the door is open fully. Slide the shelf forward and tilt from position. Split glass shelf The split shelf can be used as a standard shelf but also as two half shelves. The front half can be repositioned above or below to enable storage of larger items. Note : Only the front half of the shelf can be repositioned, the back half must remain in its original position. 10 Useful Advice Salad Bins For the storage of fruit, vegetables and salad items. When storing vegetables, remove unusable leaves and soil and leave lettuce, cabbage and cauliflower on the stem. It is advisable to clean the salad bin regularly, it can be removed by sliding it out from position. WARNING: Switch off electrical supply and pull out the mains plug. Remove all door furniture and all loose items/fittings from inside the fridge. If you have previously set up and used the fridge and since decided to reverse the doors, you must remove stored food, wrap or cover it and place into insulated containers to keep cool whilst carrying out this operation. Note : You may require assistance to do this: Support the door and using a screwdriver, remove the screw securing the top hinge. Lower the top hinge and carefully tilt the door to remove the hinge from the cabinet. Remove the top hinge from the door. 5. Remove the spacing washers from the bottom hinge pin. Unscrew the fixing screwdriver or a 5mm screw to remove the spanner, to unscrew right hand hinge cover and remove the plate. Replace the right hand cover plate with its original screw. Take the plastic cap from the left hand cover plate and use it to fill the hole on the right hand cover plate. CLEANING & MAINTENANCE 10. Unscrew the fixing screw to remove the left hand hinge cover plate. Replace the left hand cover plate with its original screw. 11. [. . . ] This can be louder when it is first switched on. This sound will reduce over the first few months. Gases flowing through the pipes can produce gurgling, bubbling, roaring or humming noises. The temperature control can make a clicking noise when it turns the motor on and off. [. . . ]