User manual HOTPOINT-ARISTON HB9314

[. . . ] Installation Hotpoint Service Cover Key contacts 3 4 5 6 7 8 9 - 14 15 Back Cover Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance. If you sell or pass the appliance to someone else, or move house and leave it behind, make sure this Book is also provided so the new owner can become familiar with the appliance and safety warnings. If the Book is lost or damaged a copy may be obtained from GDA Ltd, Morley Way, Peterborough, PE2 9JB. 2 FP087-01 HP Gas Hob (BG05) 12/09/2001 4:59 pm Page 3 INTRODUCTION Your new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully. The hob is designed specifically for domestic use and responsibility will not be accepted for use in any other installation. * The guarantee is subject to the provisions that the appliance: (a) (b) (c) (d) Has been used solely in accordance with the Users Instruction Book. [. . . ] Caustic cleaners such as these will etch the surface and attack the metal frame. Bath and sink cleaners may mark the surface. VITREOUS ENAMEL HOB, PAN SUPPORTS AND BURNER CAPS. Wipe with a cloth wrung out in hot soapy water. Stubborn stains can be removed with a cream paste or liquid cleaner. STAINLESS STEEL. Wipe with a cloth wrung out in hot soapy water followed by a wipe with a cloth wrung out in clear water and then dried with a soft clean cloth. ALUMINIUM BURNER BODIES AND RINGS. Wipe with a cloth wrung out in hot soapy water only; do not use abrasives. Use a nylon brush to remove any cleaning materials, water or dirt from the burner bodies. Re-assemble as in the diagram below. CONTROL KNOBS. Wipe over the knobs with a soft cloth wrung out in hot soapy water or mild non-abrasive cleaner. Then, after wiping with a cloth wrung out in clear water, dry with a soft clean cloth. Never use scouring pads or abrasive cleaners/powders which may scratch the surface. BURNER ASSEMBLY 7 FP087-01 HP Gas Hob (BG05) 12/09/2001 4:59 pm Page 8 SOMETHING WRONG ? IF THE IGNITION DOES NOT WORK Is the electricity switched on?If the electricity supply has failed, the burners can be lit with a match. If only a hotplate burner is failing to ignite, check that the burner body and cap are seated correctly and that the slots in the burner body are not blocked (see care and cleaning). May we wish you many years of carefree successful cooking. Disposal of your product To minimise the risk of injury to children please dispose of your product carefully and safely. Remove all doors and lids (where fitted). 50Hz Heat resistant PVC 85oC 0. 75mm2 Flexible cord. Natural Gas BURNER Front Left Rear Right and Rear Left Front Right HEAT INPUT 3. 0 kW 2. 0 kW 1. 15kW INJECTOR 130 105 80 LPG HEAT INPUT 3. 0 kW 2. 0 kW 1. 15kW INJECTOR 92 72 55 10 FP087-01 HP Gas Hob (BG05) 12/09/2001 4:59 pm Page 11 INSTALLATION INSTRUCTIONS Prior to installation, ensure that the local distributions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the rating plate which is fitted on the underside of the base panel. This appliance is not designed to be connected to a combustion products evacuation device. It must be installed and connected in accordance with current installation regulations. Particular attention should be given to the relevant requirements regarding ventilation. GAS SAFETY (INSTALLATION & USE) REGULATIONS It is the law that all gas appliances are installed by competent persons in accordance with the current edition of the above regulations. It is in your interest and that of safety to ensure compliance with the law. In the UK, CORGI registered installers work to safe standards of practice. The cooker must also be installed in accordance with BS 6172: Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution. LOCATION The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or shower. The cooker must not be installed in a bedsitting room of less than 20m3. PROVISION FOR VENTILATION The room containing the cooker should have an air supply in accordance with BS 5440: Part 2. Lower the hob into the worktop ensuring the mains lead is fed into the base unit and is not trapped under the flanges. Fix the hob to the worktop using the fixing brackets and screws. [. . . ] There is also an option of Service Cover with Maintenance at an additional cost. This includes an annual Electrical and Safety check and replacement of any parts as necessary. Hotpoint's Free Five Year Guarantee From the moment your appliance is delivered Hotpoint guarantees it for FIVE YEARS. · In the Five Years all replacement parts are FREE provided that they are fitted by our own Service Engineer. During the first year our Engineer's time and labour is also free. [. . . ]