User manual HOTPOINT-ARISTON HBFF62

[. . . ] Check your local voltage and the shape of the plug before purchasing. When you use the VOR system in a noisy place, the unit will stay in the recording mode. If the sound is too soft, on the contrary, the unit will not start recording. Set VOR to H (high) or L (low) depending on the conditions to pick up necessary sound only. [. . . ] â· When you do not use the unit for a long time, remove the batteries to avoid any damage caused by battery leakage and subsequent corrosion. â· Dry batteries will not be expended when another power source is connected. You can record right away with the built-in microphone. Make sure that nothing is connected to the MIC jack. Place the unit on a hard surface such as a desk with the cassette holder side up so that the flat mic can record effectively. Replace the batteries with new ones when the BATT/REC lamps go off and the i lamp flashes. To reuse the tape for recording, cover the tab hole with adhesive tape. 4cm/s): for double recording time (for example, 120 minutes using both sides of a 60-minute cassette). suitable for recording conferences , dictations , etc. set VOR to: H or L to start and pause recording automatically to the sound. H (high) to record at meetings or in a quiet and/or spacious place. â· If the unit has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a tape. When recording with an external microphone, the VOR system may not work properly due to difference in sensitivity. Connect another equipment to the MIC jack using the RK-G64HG connecting cord (not supplied). We do not recommend the use of tapes longer than 90 minutes except for a long continuous recording or playback. they are very thin and tend to be stretched easily. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. 2 mV for 3 kilohms or lower impedance microphone Output Earphone jack (minijack) for 8 - 300 ohms earphone Variable range of the tape speed from approx. ) Design and specifications are subject to change without notice. Insert a cassette with the side to be played facing the cassette holder. There is a raised dot beside VOL to show the direction to turn down volume. Turn SPEED CONTROL to: SLOW (slow) to play back at a slower speed. [. . . ] FAST (fast) to play back at a faster speed. To clean the tape heads and path depress r REC while pushing the lever. Wipe the heads, pinch roller, and the capstan with a cotton swab moistened with alcohol after every 10 hours of use. Use a soft cloth slightly moistened in water. [. . . ]