User manual HOTPOINT-ARISTON HBRLA80

[. . . ] LARDER FRIDGE - MODEL RLA80, RLM80, RLS80 INSTRUCTIONS FOR INSTALLATION & USE GETTING STARTED: STEP 1 Choose a location for your fridge, away from any heat sources and allow adequate ventilation - 100mm (4 inches) gap above. To ensure that your fridge runs reliably and efficiently follow these steps. STEP 2 Move the fridge into position, using the sides of the cabinet. Take care to avoid damaging the refrigerant circuit pipe work on the rear. SAFETY & INSTALLATION CONTROLS STEP 3 To prevent the fridge tilting forwards it must be held in place with the stability bracket supplied. STEP 4 Level the fridge by adjusting the front feet. This will stop rocking or vibration and keep the door aligned. NB. [. . . ] WARNING: Do not use abrasive powder, household cleaner, bleach or wax polish to clean the interior, they will leave a smell in the fridge. Remove stored food, wrap or cover it and place into insulated containers to keep cool whilst cleaning. Remove salad bins, racks and shelves from the fridge compartment. Wash in warm water and washing up liquid using a soft cloth, dry thoroughly. DO NOT use any cleaning agents on the wine rack, just wipe with a soft cloth. Wipe the interior and fittings with a clean cloth wrung out in a solution of either one teaspoon of bicarbonate of soda to one pint of water or MiltonTM sterilising fluid, diluted according to the manufacturer's instructions. Dry the interior thoroughly with a clean cloth before replacing fittings and food. Note : It is important to ensure that cleaned shelves, racks and bins are thoroughly dried before refitting to the fridge compartment. CLEANING & MAINTENANCE 3. 4. Exterior WARNING: Do not use abrasive powder, household cleaner or bleach they can damage the exterior of your fridge. Use a clean soft cloth wrung out in warm water and washing up liquid to wipe the exterior surface, dry thoroughly. Use a soft brush or vacuum cleaner to remove dust from underneath the fridge and from the compressor and condenser situated at the back of the fridge WARNING: Do not damage the pipework. Door Seal Use warm water and a clean soft cloth to wipe along and in between the creases of the door seal, dry thoroughly. Take care not to damage the seal and avoid using sharp objects. WARNING: Do not use detergent, it will damage the seal. 13 Maintenance Going Away If you are going away and don't want to use your fridge, switch off the electricity supply and pull out the mains plug. Remove food and follow the cleaning instructions on the previous page. Note : Leave the door ajar to prevent an accumulation of odours. Changing the Light Bulb WARNING: Switch off electricity supply and pull out the mains plug Obtain a replacement SES 15 watt bulb from the Hotpoint Genuine Parts and Accessories Mail Order Hotline (see KEY CONTACTS back page) and fit as follows : 1. Remove any shelves from directly below the interior light, to make access easier. Squeeze the side of the lamp guard lightly to unclip. Plug in and switch on electrical supply. CLEANING & MAINTENANCE 14 Door Reversal Door Reversal You will need a cross head screwdriver, a flat blade screwdriver and a 5mm spanner to carry out this procedure. Our Service Department can arrange for an Engineer to do the conversion for you but a charge will be made. WARNING: Switch off electrical supply and pull out the mains plug. [. . . ] Expansion and contraction of parts inside the fridge can produce a cracking noise as they rapidly change temperature. 17 TROUBLESHOOTING Hotpoint guarantee "Satisfaction guaranteed or your money back" We give you a unique `satisfaction guaranteed' promise - valid for 90 days - after you have purchased your Hotpoint appliance. If there is a technical problem simply call Hotpoint Repair service or visit our web-site at www. theservicecentre. co. uk and where necessary, we will arrange for an engineer to call. If the technical problem is not resolved under this guarantee, we will replace your machine or, if you prefer, give you your money back. All Hotpoint appliances carry a fully inclusive 12 month parts and labour guarantee as well as free replacement parts for the first 5 years (except microwaves, selected integrated appliances and cooker hoods, which have a one year guarantee) provided that they are fitted by a Hotpoint engineer. [. . . ]