User manual HOTPOINT 7OFHR640

[. . . ] 7OFD 610 RU/HA 7OFHR 640 RU/HA 7OFHR 640 RU/HA S English Operating Instructions OVEN Contents Operating Instructions, 1 Warnings, 2 Assistance, 3 Description of the appliance, 4 Description of the appliance, 5 Installation, 6 Start-up and use, 8 Modes, 8 Precautions and tips, 11 Maintenance and care, 11 Русскии Руководство по эксплуатации ДУХОВОЙ ШКАФ Содержание Руководство по эксплуатации, 1 Предупреждения, 2 Сервисное обслуживание, 3 Описание из елия , 4 Описание из делия, 5 Установка, 13 Включение и эксплуатация, 15 Программы, 16 Предосторожности и рекомендации, 18 Техническое обслуживание и уход, 19 Warnings WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] In case of blackouts lasting over 10 seconds, the programmer stops: when current is restored, the CLOCK icon flashes to indicate that a blackout has occurred and that the time must be set again. Setting the time To adjust the time indicated by the hands, briefly press the TIME SETTING knob until the CLOCK icon starts flashing. Then, to increase or decrease the displayed time setting in 1-minute steps, turn the knob clockwise or anti-clockwise; the minutes hand moves clockwise or anticlockwise accordingly, in 1-minute steps. Once 10 seconds have elapsed since the most recent adjustment, the programmer automatically exits the adjustment mode. This function does not interrupt cooking nor does it affect the oven’s operation; it is simply used to activate the buzzer when the set duration has elapsed. To activate the minute minder, briefly press the TIME SETTING knob until the MINUTE MINDER icon starts flashing. To increase or decrease the set duration, turn the TIME SETTING knob clockwise or anti-clockwise; the minutes hand will move in 1-minute steps. The MINUTE MINDER icon flashes continuously for 10 seconds after the most recent rotation. The setting can be confirmed by pressing the TIME SETTING knob or letting 10 seconds elapse, provided that a cooking time of at least 1 minute has been programmed. The switched-on MINUTE MINDER icon indicates that the duration has been set; the countdown will start immediately. Select the desired cooking mode using the PROGRAMMES knob. To view the set duration, briefly press and release the TIME SETTING knob; the hands and icons will display the remaining minutes. 8 At the end of the set time, the MINUTE MINDER icon flashes and the buzzer sounds for 1 minute (to silence it, briefly press the knob). To cancel the setting, press the TIME SETTING knob for 3 seconds: the programming will be cancelled and the MINUTE MINDER icon will switch off. A temperature value can be set for all cooking modes between 60°C and Max, except for • GRILL (recommended: set only to MAX power level); • GRATIN (recommended: do not exceed 200°C). The top heating element, as well as the fan, will come on. This combination of features increases the effectiveness of the unidirectional thermal radiation of the heating elements through forced circulation of the air throughout the oven. This helps prevent food from burning on the surface, allowing the heat to penetrate right into the food. Always cook in this mode with the oven door closed. BAKING mode The rear heating element and the fan are switched on, thus guaranteeing the distribution of heat in a delicate and uniform manner throughout the entire oven. This mode is ideal for baking temperature sensitive foods (such as cakes, which need to rise) and for the preparation of “bitesize pastries” on 3 shelves simultaneously. The Rotisserie* To operate the rotisserie (see diagram) proceed as follows: 1. [. . . ] This will not affect the rust protection. € The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. [. . . ]