User manual HOTPOINT AQD1070D 49 EU/B

[. . . ] WASHER-DRYER This symbol reminds you to read this instruction manual. EN EN English, 1 PL Polski, 13 GR ΕΛΛΗΝΙΚΑ, 25 Contents Installation, 2-3 CZ Česky, 37 Unpacking and levelling Connecting the electricity and water supplies Technical data Description of the machine, 4-5 Touch control panel How to run a wash cycle or a drying cycle, 6 Wash cycles and options, 7 Table of wash cycles Wash options Detergents and laundry, 8 AQUALTIS AQD1070D 49 Detergent Preparing the laundry Washing recommendations Load balancing system Precautions and advice, 9 General safety Disposal Opening the porthole door manually Care and maintenance, 10 Cutting off the water and electricity supplies Cleaning the machine Cleaning the detergent dispenser drawer Caring for your appliance drum Cleaning the pump Checking the water inlet hose Trouble shooting, 11 Assistance, 12 1 Installation EN !This instruction manual should be kept in a safe place for future reference. If the Washer-dryer is sold, given away or moved, please ensure the manual is kept with the machine, so that the new owner may benefit from the advice contained within it. [. . . ] 90°C) The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. (*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display. For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 50229: set wash cycle with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle with a temperature of 40°C. 4) Long wash cycle for synthetics: set wash cycle with a temperature of 40°C. Wash options This option offers a highperformance wash due to 3 the greater quantity of water used in the initial phase 1 of the cycle, and due to the increased wash cycle 2 duration, is particularly useful for the removal of stubborn stains. If you desire bleaching, insert the extra tray compartment (3) into compartment 1. When pouring in the bleach, be careful not to exceed the “max” level marked on the central pivot (see figure). To bleach laundry without carrying out a full wash cycle, pour the bleach into the extra compartment 3, select the “Rinse” cycle and activate the “Super Wash” option . It cannot be used in conjunction with , , , , , , , , , , Super Wash sensitive to detergents. We recommend this option is used with a full load of washing, or when a large amount of detergent is required. It cannot be used in conjunction with , , , , , , , . By selecting this option, the wash and spin cycles will be modified in order to reduce the formation of creases. At the end of the cycle the Washer-dryer drum will rotate slowly; the “Easy Iron” and START/PAUSE indicator lights will flash. To end the cycle press the START/PAUSE button or the “Easy Iron” button. It cannot be used in conjunction with , , , , , Note: If you also want to run the drying cycle, this option is enabled only if combined with level “Iron”. If you select this option, the wash cycle duration will be reduced by up to 50%, depending on the selected cycle, thereby guaranteeing simultaneous water and energy saving. Use this cycle for lightly soiled garments. It cannot be used in conjunction with , , , , , , , , , , . By selecting this option, the efficiency of the rinse is increased and optimal residual detergent removal is guaranteed. [. . . ] €¢ If you have selected the function, at the end of the cycle the Washer-dryer drum will rotate slowly; to end the cycle press the START/PAUSE button or the button. The machine continuously fills with • The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”). €¢ The free end of the hose is under water (see “Installation”). €¢ If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the Washer-dryer to fill with water and drain continuously. [. . . ]