User manual HOTPOINT AQLF9D 49 U

[. . . ] 31 PT 32 Instructions for installation and use Contents EN English WASHING MACHINE EN Installation, 34-35 Unpacking and levelling Connecting the electricity and water supplies Technical data Description of the machine, 36-37 Touch control panel Auto Dose System, 38-39 Running a wash cycle, 40 Wash cycles and options, 41 Table of wash cycles Wash options Detergents and laundry, 42 AQUALTIS AQLF9D 49 U Detergent Preparing the laundry Washing recommendations Load balancing system Precautions and advice, 43 General safety Disposal Opening the porthole door manually Care and maintenance, 44 Cutting off the water and electricity supplies Cleaning the machine Cleaning the detergent dispenser drawer Caring for your appliance drum Cleaning the pump Checking the water inlet hose Trouble shooting, 45-46 Assistance, 47 33 Installation EN !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, given away or moved, please ensure the manual is kept with the machine, so that the new owner may benefit from the advice contained within it. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] To change a wash cycle once it has already started, pause the washing machine by pressing the START/PAUSE button; then select the desired cycle and press the START/ PAUSE button again. To open the door during a wash cycle, press the START/PAUSE button; if the DOOR LOCKED indicator light is switched off you may open the door. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted. This is indicated by T the illuminated text END. The porthole door may be opened immediately. If the START/PAUSE indicator light is flashing, press the button to end the cycle. Open the door, unload the laundry and switch off the machine. If you wish to cancel a cycle which has already begun, press and hold the button until the cycle stops and the machine switches off. Bag for quilts, curtains and delicate garments The Aqualtis washing machine makes it easier for you to wash even the most valuable and delicate garments in complete confidence thanks to the special bag which protects the laundry (this is supplied with the machine). We recommend that the bag is used every time you wash quilts and padded items with an outer layer made using synthetic material. Wash cycles and options Table of wash cycles Icon Description of the wash cycle Cottons wash cycles Cottons with pre-wash (Add detergent to the relevant compartment). Mix 30': to refresh lightly soiled garments quickly (not suitable for wool, silk and clothes which require washing by hand) Partials wash cycles Rinse Spin Drain Detergent and additives Max. Cycle speed load Fabric (°C) Prewash Wash Bleach (kg) duration (rpm) softener 90° 1400                                        9 9 9 9 2 4 4 4 4 9 3, 5 2 2 3, 5 9 9 9 EN (*) The duration of the wash cycles can be checked on the display. 90°C) 40° 1400 40° 1400 40° 600 40° 800 40° 60° 40° 60° 30° 30° 40° 30° 800 800 800 1400 1200 0 600 800 1400 1400 0 The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. (*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display. For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 60456: set wash cycle with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle with a temperature of 40°C. Wash options This option offers a highperformance wash due to 1 the greater quantity of water used in the initial phase of 3 the cycle, and due to the 2 increased wash cycle duration, is particularly useful for the removal of stubborn stains. If you desire bleaching, use the compartment 3. When dosing the bleach, be careful not to exceed the “max” level (see figure). [. . . ] Fabric softener has been added instead of detergent or vice-versa) • Two different types of detergent/fabric softener have mixed. NEVER mix two different detergents; always clean out the tanks before adding a new type of detergent. €¢ The “Auto Dose System” is blocked due to prolonged lack of use: carry out a tank cleaning cycle (refer to “Cleaning cycle set by the user”). What happens if the tanks are loaded even if they are already full? [. . . ]