User manual HOTPOINT ARL 105

[. . . ] Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Do not expose batteries or apparatus with battery-installed to excessive heat such as sunshine, fire or the like. The unit is not disconnected from the mains as long as it is connected to the AC outlet, even if the unit itself has been turned off. [. . . ] 3) Folder numbers are assigned serially thereafter up to the maximum 999. 4) File numbers are assigned serially thereafter. 5) A new file is created in the "REC1" folder each time REC1 is performed. 6 14GB Notes · When transferring music from a CD, the tracks are transferred as 128 kbps MP3 files. When transferring music from an MP3 disc, MP3 files are transferred at the same bit rate as that of the original MP3 files. · If you start transferring in shuffle play mode, repeat play mode or in program play mode (when no tracks or MP3 files are programmed), the selected play mode is automatically cancelled and the play mode switches to normal play mode. · While transferring music from an MP3 disc, no sound is output and "HI-SPEED" appears. · CD text information is not transferred in the created MP3 files. · If you cancel the process in the middle of music transfer, an incomplete MP3 file will be created up to the point when the transfer was stopped. · Transferring stops automatically if: ­ the USB device runs out of space. ­ the number of audio files on the USB device reaches the limit for the number that the system can recognize. · If the folder to be erased contains non-MP3/ WMA/AAC format files or sub folders, these are not erased. Adjust the component's volume accordingly. See "To turn off the automatic standby function" (page 27). · Make sure to turn down the volume to minimum level before connecting or disconnecting an audio component. Otherwise, noise may be generated, the system may malfunction, or "PROTECT" may appear on the display (page 22). To cancel Program Play Press PLAY MODE repeatedly until "PGM" disappears while the player is stopped. To delete the last track or file of the program Press CLEAR while the player is stopped. To view program information, such as total track number of the program Press DISPLAY repeatedly. 17GB Adjusting the sound To Press Changing the display To Press Generate a more DSGX on the unit. dynamic sound (Dynamic Sound Generator X-tra) Set the sound effect EQ. Change DISPLAY repeatedly information on the when the system is display* turned on. Change Display mode (See below. ) DISPLAY repeatedly when the system is turned off. To turn on the subwoofer (MHCEX99/EX900 only) 1 2 3 Press OPTIONS on the unit. Press . /> repeatedly to select "S-WOOFER, " and then press ENTER. Press . /> repeatedly to select "SW ON, " and then press ENTER. To turn off the subwoofer, select "SW OFF, " and then press ENTER. * For example, you can view CD/MP3 disc information or the USB device information, such as: ­ track or file number during normal play. ­ track or file name (" ") during normal play. ­ artist name (" ") during normal play. [. . . ] · Turn off nearby electrical equipment. To change the AM tuning interval (Except for European, Russian and Saudi Arabian models) The AM tuning interval is preset to 9 kHz or 10 kHz by factory default. 1 2 3 Tune to any AM station, and then turn off the system. While holding down TUNING + on the unit, press ?/1 on the unit. To reset the interval to the factory preset, repeat the procedure. To reset the system to factory settings If the system still does not operate properly, reset the system to factory settings. You cannot reset the system to factory settings in Power Saving Mode. [. . . ]