User manual HOTPOINT ARTL 120

[. . . ] FR 65 - 100 cm Raccorder le tuyau d’évacuation, sans le plier, à un conduit d’évacuation ou à une évacuation murale placés à une distance du sol comprise entre 65 et 100 cm; Premier cycle de lavage ou bien l’accrocher à un évier ou à une baignoire, dans ce cas, fixer le support en plastique fourni avec l’appareil au robinet (voir figure). 12 Instructions for use WASHING MACHINE Contents GB English GB Installation, 14-15 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Description of the washing machine and starting a wash cycle, 16-17 Control panel Indicator lights How to open and shut the drum Starting a wash cycle Wash cycles, 18 Table of wash cycles ARTL 120 Personalisation, 19 Setting the temperature Setting the spin speed Functions Detergents and laundry, 20 Detergent dispenser drawer Bleach cycle Preparing the laundry Garments requiring special care Load balancing system Precautions and tips, 21 General safety Disposal Saving energy and respecting the environment Care and maintenance, 22 Cutting off the water or electricity supply Cleaning the washing machine Caring for your appliance door and drum Cleaning the pump Checking the water inlet hose How to clean the detergent dispenser Troubleshooting, 23 Service, 24 13 Installation GB  Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washing machine to inform the new owner as to its operation and features.  Read these instructions carefully: they contain vital information on installation, use and safety. [. . . ] Extra rinse (Rinçage plus) By selecting this function, the efficiency of the rinse is increased and optimal detergent removal is guaranteed. it is particularly useful for sensitive skin.  This function may not be used in conjunction with wash cycles , , , , . Easy iron (Repassage facile) By selecting this function, the wash and spin cycles will be modified in order to reduce the formation of creases. At the end of the cycle the washing machine will perform slow rotations of the drum. Wash cycle, the machine will end the cycle while the laundry is soaking, the EASY IRON and START/ For the PAUSE indicator lights will flash (orange) and the RINSE phase will remain lit in a fixed manner. To drain the water so that the laundry may be removed, press the START/PAUSE button or the EASY IRON button.  This function may not be used in conjunction with wash cycles Delay timer (Départ différé) , , , , , , , , . This timer delays the start time of the wash cycle by up to 12 hours. Press the button repeatedly until the indicator light corresponding to the desired delay time switches on. The fifth time the button is pressed, the function will be disabled. Once you have pressed the START/PAUSE button, the delay time may only be decreased if you wish to modify it.  This option is enabled with all programmes. 19 Detergents and laundry GB Detergent dispenser drawer Good washing results also depend on the correct dose of detergent: adding too much detergent won't necessarily make for a more efficient wash, and may in fact cause build up on the interior of your appliance and even pollute the environment. Open up the detergent dispenser and pour in the detergent and fabric softener, as follows. Preparing the laundry • Divide the laundry according to: - the type of fabric/the symbol on the label - the colours: separate coloured garments from whites. Empty all garment pockets and check the buttons. • Do not exceed the listed values, which refer to the weight of the laundry when dry: Durable fabrics: max. 1 1 1 1 1 compartment 1: Detergent for pre-wash compartment 2: Detergent for the wash cycle (powder or liquid) It is recommended that you place liquid detergent directly into the compartment using the appropriate dosing cup. compartment 3: Additives (softener , etc. ) When pouring the softener in compartment 3, avoid exceeding the "max" level indicated. The softener is added automatically into the machine during the last wash. [. . . ] a delayed start has been set (see “Personalisation”). The water inlet hose is not connected to the tap. The START/PAUSE button has not been pressed. The washing machine does not take in water (the indicator light for the first wash cycle stage flashes rapidly). [. . . ]