User manual HOTPOINT ASL 60 VX

[. . . ] Instruction booklet TUMBLE DRYER GB English, 1 F Français, 14 D Deutsch, 27 Contents Installation, 2-3 Where to put your dryer Ventilation Electrical connection Before you start using your dryer GB NL E P Português, 66 Nederlands, 40 Español, 53 Dryer description, 4 The front The back Control panel Start and programmes, 5-7 Choosing a programme Table of programmes The controls ASL60V ASL60VX Laundry, 8-9 Sorting your laundry Wash care labels Special clothing items Drying times Warnings and Suggestions, 10 General safety Disposal Saving energy and respecting the environment Maintenance and Care, 11 Switching off the electricity Cleaning the filter after each cycle Check the drum after each cycle Cleaning the dryer Troubleshooting, 12 Service, 13 Spare parts 1 Installation GB !Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and, should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the dryer so that the new owner may be informed about warnings and suggestions on how the dryer works. Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works. [. . . ] Q OPTION buttons / lights These buttons are used to customise the selected programme to your requirements. The delay time is displayed in hours and counts down each hour. The time to end is displayed in hours and minutes and counts down each minute, this includes the cool tumble phase. When timed programmes are selected the time displayed throughout the cycle is the actual time remaining. When a sensing programme is selected the time displayed is an estimate of the time remaining. When the programme is selected the display shows the time required to dry a full load, after around 10 minutes the controller calculates a better estimate of the cycle time. The colons between the hours and minutes in the display flash to show that the time is counting down. When the programme finishes its cool tumble phase the display will show E88 . The display also shows if there is a problem with your dryer, if this occurs the display will show F followed by a fault code number (see Troubleshooting). Q GB Installation Description Start and Programmes Laundry Door Opening Opening the door during a programme will stop the dryer and have the following effects: q All 4 progress lights come on. Q During a delay phase the delay will continue to count down. The start button must be pressed to resume the delay programme. The progress lights will change to show current status. Q During the drying part of the programme, the time to end count continues but the colons do not flash. The start button must be pressed to resume the programme. The progress lights will change to show the current status. high Heat When available this button selects high heat. Pressing the start button will re-start a new programme at the beginning. Q Changing the programmes knob will select a new programme, after you press the start button. You can use this to select the Cool Tumble programme to cool the clothes, if you find them dry enough. Q Warnings and Suggestions Maintenance and Care Troubleshooting Service Note If you have a power cut, switch off the power or remove the plug, press the START button and the programme will resume. 7 Laundry GB Sorting your laundry q Wash Care Labels Look at the labels on your garments, especially when tumble drying for the first time. [. . . ] Have your dryer checked regularly by authorised technicians to ensure electrical and mechanical safety (see Service). Maintenance and Care Troubleshooting Service 11 Troubleshooting GB One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: Problem: The tumble dryer won’t start. Possible causes / Solution: q q q q q q q The plug is not plugged into the socket, or not making contact. [. . . ]