User manual HOTPOINT AVSF 129

[. . . ] Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washing machine to inform the new owner as to its operation and features.  Read these instructions carefully: they contain vital information on installation, use and safety. Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine. [. . . ] Press button and the maximum temperature allowed for the needs to be regulated, a fixed programme set will be displayed and the icon flashes. Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the remains fixed. Desired value, after approximately 2 seconds the setting is accepted: the symbol The temperature adjustment is enabled with all wash programmes. Press the button and you will see the word OFF on the display, while the relative symbol flashes. Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the "desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the set remains on. Programme appears on the display and the symbol If you now press the START/RESET button, the set "delay" appears; this decreases every hour until the start of the cycle. In this phase, the "delay" can only be modified by decreasing it. The Delay Timer regulation is enabled with all programmes. Setting the temperature Programmes Setting the delay Timer Detergents Keyboard Lock Functions (see page 5). Press the button corresponding to the desired function, according to the table below; 2. The function is enabled when the corresponding button is illuminated. Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled. Function Effect Allows for an impeccable wash, visibly whiter than a standard Class A wash. This option reduces the amount of creasing on fabrics, making them easier to iron. Cuts the duration of the wash cycle by 30%. Comments Enabled with programmes: 1, 2, 3, 4, 5, 6, 7, 8 Precautions Care Super wash This option is incompatible with the RAPID option. Troubleshooting Easy iron If you set this option, programmes 6, 7, 8, 11 and Delicate Rinse will be suspended, leaving the laundry to soak (Anti-crease) and EASY IRON button will flash: - to conclude the cycle, press the START/RESET button or EASY IRON button; - to run the draining cycle alone, set the knob to the relative symbol and press the START/RESET button. This option is incompatible with the SUPER WASH option. all programmes except for 1 , 2 , 9 , 10 , Spin cycles and Draining. 5 kg Delicate fabrics: max 2 kg Wool: max 1 kg How much does your laundry weigh?1 1 1 1 1 sheet 400-500 g pillow case 150-200 g tablecloth 400-500 g bathrobe 900-1, 200 g towel 150-250 g 8 Precautions and advice  The washing machine was designed and built in compliance with the applicable international safety regulations. [. . . ] • • • • • • The water inlet hose is not connected to the tap. The START/RESET button has not been pressed. • The drain hose is not fitted between 65 and 100 cm from the floor (see page 3). • The free end of the hose is underwater (see page 3). [. . . ]