User manual HOTPOINT BCB 312 AI S/HA

[. . . ] 00 01/2007 - Xerox Business Services PT 32 Operating Instructions REFRIGERATOR/FREEZER COMBINATION Contents I Italiano, 1 GB English, 11 P Portuges, 21 Installation, 12 GB Positioning and connection Description of the appliance, 13 Overall view Start-up and use, 14-15 Starting the appliance Setting the temperature Using the refrigerator to its full potential Using the freezer to its full potential Maintenance and care, 16 BCB BCB BCB BCB BCB BCB 311 311 312 312 312 312 AI IT/HA AI IT S/HA AI/HA AI S/HA AAI/HA AAI S/HA Switching the appliance off Cleaning the appliance Avoiding mould and unpleasant odours Defrosting the appliance Replacing the light bulb Precautions and tips, 17 General safety Disposal Respecting and conserving the environment Troubleshooting, 18 Assistance, 19 Installation GB !Before placing your new appliance into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. [. . . ] If the room temperature drops below 14°C for an extended period of time, the ideal temperature will not be reached in the freezer compartment and food preservation will be reduced. ICE CARE tray GB The fact that they are situated on the top part of the freezer drawers ensures greater cleanliness: the ice no longer comes into contact with the food placed inside the freezer compartment; furthermore, the dripping of the water during filling is avoided (a lid to cover up the hole after filling with water is also provided). Check that the tray is ompletely empty and fill it with water through the opening provided. Take care not to exceed the level indicated (MAX WATER LEVEL). Excess water prevents the ice cubes from dispensing (if this happens, wait for the ice to melt and empty the tray). Turn the tray 90°: due to the connected compartments each mould fills with water (see diagram). Close the opening with the lid provided and put the tray back. When the ice has formed (minimum time approximately 8 hours) knock the tray against a hard surface and wet the outside so that the ice cubes come loose and take them out through the opening. mAX WATER LEVEL MAX * Available only on certain models. 15 WATER LEVEL Maintenance and care GB Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply. It is not sufficient to set the temperature adjustment knobs on 0 (appliance off) to eliminate all electrical contact. Defrosting the freezer compartment If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. Set the TEMPERATURE ADJUSTMENT knob to the position 0 . Wrap frozen foods in newspaper and place them in another freezer or in a cool place. Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment. Certain appliances are fitted with the DRAIN SYSTEM to lead the water outside: insert the scraper into the slot provided at the bottom and let the water flow into a container (see diagram). Clean and dry the freezer compartment carefully before switching the appliance on again. Until the ideal storage conditions have been restored, before placing food in the freezer compartment. Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. [. . . ] Ensure that it is protected from direct sunlight and do not place it near heat sources. Possible causes / Solutions: • The plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house. • • • • • The doors do not close properly or the seals are damaged. The TEMPERATURE ADJUSTMENT knob is not in the correct position The refrigerator or the freezer have been over-filled. [. . . ]