User manual HOTPOINT BCB333 AVEI FF

[. . . ] Operating Instructions REFRIGERATOR/FREEZER COMBINATION Contents GB English GB Installation, 2 Positioning and connection Description of the appliance, 3-4 Overall view Control panel Start-up and use, 5-6-7-8 Starting the appliance Using the display Using the refrigerator to its full potential Using the freezer to its full potential Maintenance and care, 9 BCB 333 AVEI FF (AUS) Switching the appliance off Cleaning the appliance Avoiding mould and unpleasant odours Defrosting the appliance Replacing the light bulb PURE WIND PLUS Filter maintenance Precautions and tips, 10 General safety Disposal Respecting and conserving the environment Troubleshooting, 11 Assistance, 12 Installation GB !Before placing your new appliance into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. [. . . ] Check that the tray is completely empty and fill it with water through the opening provided. Take care not to exceed the level indicated (MAX WATER LEVEL). Excess water prevents the ice cubes from dispensing (if this happens, wait for the ice to melt and empty the tray). Turn the tray 90°: due to the connected compartments each mould fills with water (see diagram). Close the opening with the lid provided and put the tray back, placing the top part in the corresponding housing and allowing it to drop in again. When the ice has formed (minimum time approximately 8 hours) knock the tray against a hard surface and wet the outside so that the ice cubes come loose and take them out through the opening. ICE PARTY: tensures bottles of sparkling wine or champagne reach the right temperature. Place the bottle in the prefrozen ice bucket located inside the FREEZER and STORAGE compartment and select the function on the display. Remove the bottle when the alert is given. The bucket may be used to serve the bottle, keeping it cool after it has been removed from the appliance. MAX WATER LEVEL MAX WATER LEVEL 8 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: 1. set the FREEZER OPERATION and APPLIANCE ON/ OFF Knob on Off 2. If this procedure is not followed, the alarm may sound. This alarm does not indicate a malfunction. To restore normal operation, it is sufficient to set the FREEZER OPERATION and APPLIANCE ON/OFF knob on the desired value. To disconnect the appliance, follow point 1 and 2. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb (A) by unscrewing the fixing screw (B) which is located at the back of the lampcover, as shown (see diagram). Replace it with a similar light bulb, the power of which should not exceed 15W. GB A Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia. • The removable accessories may be soaked in warm water and soap or dishwashing liquid. Rinse and dry them carefully. B Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. PURE WIND PLUS Filter maintenance Unhook the filters from the left side of the cover by inserting the tip of a small screwdriver into the gaps (see attached pictures). Wash the filters regularly (every 12-18 months) under running water, using a neutral detergent to remove any stubborn build-up. [. . . ] • The food is in contact with the back inside wall of the refrigerator. • The SUPER COOL and/or SUPER FREEZE and/or ICE PARTY functions are enabled (see Description). • The door is not closed properly or is continuously opened. • The outside ambient temperature is very high. [. . . ]