User manual HOTPOINT CG65SG5 X UA /HA

[. . . ] Operating Instructions COOKER GB GB English, 1 RS UA Contents Installation, 2-6 Positioning and levelling Electrical connection Gas connection Adapting to different types of gas Technical data Table of burner and nozzle specifications РУССКИЙ, 13 Украінська, 26 RO Romanian, 37 Description of the appliance, 7 Overall view Control panel Start-up and use, 8-10 CG65SG5 UA/HA CG65SG1 UA/HA Using the hob Using the oven Oven cooking advice table Electronic timer, 9 Setting the clock and timer Precautions and tips, 11 General safety Disposal Respecting and conserving the environment Care and maintenance, 12 Switching the appliance off Cleaning the appliance Replacing the oven light bulb Gas tap maintenance Assistance Installation !Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance. Please keep these operating instructions for future reference. [. . . ] Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction. This may be the minimum setting C, the maximum setting E or any position in between the two. Several models are equipped with an ignition device which is built into the knob; in this case the electronic ignition device* is present (C) but the ignition button is not. Simply press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting, until the burner is lit. The burner may be extinguished when the knob is released. If the appliance is fitted with an electronic lighting device*, press the ignition button, marked with the symbol 1, then hold the OVEN control knob and turn it in an anticlockwise direction, towards the MAX position, until the burner is lit. If, after 15 seconds, the burner is still not alight, release the knob, open the oven door and wait for at least 1 minute before trying to light it again. If there is no electricity the burner may be lit using a flame or a lighter, as described above. The oven is fitted with a safety device and it is therefore necessary to hold the OVEN control knob down for approximately 6 seconds. If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight the oven. Adjusting the temperature To set the desired cooking temperature, turn the OVEN control knob in an anticlockwise direction. Temperatures are displayed on the control panel and may vary between MIN (150°C) and MAX (250°C). Once the set temperature has been reached, the oven will keep it constant by using its thermostat. Electronic timer* This function displays the time and works as a timer which counts down to zero. All functions will be implemented approximately 7 seconds after they have been set. Resetting the clock After the appliance has been connected to the power supply, or after a power cut, the clock display will begin to blink, showing the figure: 0:00 • Press button G and then buttons - and + to set the exact time. Press and hold the buttons to quicken the count upwards. Any necessary modifications can be made by repeating the above process. Timer feature This function may be accessed by pressing the n button, after which the display will show the symbol GB !If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight the grill. Place the rotisserie support in position 4 and insert the spit in the hole provided on the back panel of the oven. Acitvate the function by pressing the TURNSPIT button. [. . . ] Never use steam cleaners or pressure cleaners on the appliance. € The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse well and dry thoroughly. [. . . ]