User manual HOTPOINT CHA 240 SI

[. . . ] Do not attempt to operate or handle this appliance when barefoot, or with wet hands or feet. It is highly recommended that you do not operate this appliance by connecting it to the power supply with extensions or multiple socket plugs. If the refrigerator has been installed between two cabinets, make sure that the supply chord is not dangerously crimped or trapped beneath a heavy object. Never pull the cable or the appliance to remove the plug from the socket; this is exceedingly dangerous. [. . . ] Turn the fast freeze switch (E) to the Super "S" setting (the yellow D light will turn on). When the red B light turns off, change the setting for the E switch to the "N" setting. nOTICE Use average temperature settings to ensure optimum performance and to save energy. Getting the Most Out of Your Appliance Tips on Freezing - Remember that you should never refreeze products you have allowed to thaw, even if only partially. Once thawed, cook the food, then either eat (within 24 hours) or refreeze it - Consult a specialized manual when packaging foods for freezing. - For the best storage and thawing, remember to freeze small portions. this will ensure rapid and uniform freezing. Mark package with a description of the contents and the date it was frozen. - Never freeze more food than that allowed by the maximum freezing capacity indicated on the data plate which is located on the back of the freezer. - Turn the E switch to the "S" setting (the yellow D light will come on). - To freeze food, make sure that the red light is off. Then turn the fast freeze switch (E) to the "S" setting (Super). Then place the food to be frozen into the freezer, making sure that it is placed, to the furthest extent possible, in direct contact with the side walls of the deepest part of the freezer and not in contact with food that has already been frozen. It should be kept in mind, in fact, that proper storage depends on the speed at which the food is frozen. For this reason, we recommend that the switch be turned to the "S" setting 24 hours before the food to be frozen is placed inside the freezer. - Avoid opening the freezer door during the freezing process. - Placing substantial amounts of fresh food in the appliance may temporarily raise the temperature within the freezer (the red light will turn on). Since this is a temporary situation, it will not compromise the storage of the food that has already been frozen. - After 24 hours and once the freezing process has been completed, turn the freezer switch (E) to the "N" setting (yellow light is off). Attention: Do not forget to change the temperature setting if you want to avoid useless wastes of energy. - In the case of power failure or breakdown, do not open the freezer door. This will help maintain the temperature inside the freezer, ensuring that foods are conserved for at least 20 hours. [. . . ] After the inside has been cleaned, rinse well with clean water and dry carefully. Once the appliance has been cleaned, turn on the appliance, following the instructions in "Setting Up Your Appliance. " Changing the unside lamp bulb To change the bulb inside the appliances that are equipped with internal lighting, remove the bulb cover situated on the inside wall of the door by pushing the ends of the cover (Fig. Replace the old bulb with a new one of ni higher than 15 W. [. . . ]