User manual HOTPOINT CISPH 640 M

[. . . ] Congratualtions on choosing an Ariston appliance, which you will find is dependable and easy to use. We recommend that you read this manual for best performance and to extend the life of your appliance. Thank you. Close-up View A B F D C A. E. E A B Gas Burners Support Grid for Cookware Control Knobs for Gas Burners Ignitor for Gas Burners (only on certain models) Ignition Button for Gas Burners (only on certain models) F. [. . . ] Rooms in which LPG tanks are installed must be fitted with ventilation openings to the outside in order to allow the gas to escape in the event of a leak. Therefore, LPG tanks, whether empty or partially full, must not be installed or stored in rooms or spaces below ground level (cellars, ect. ). It is also a good idea to keep only the tank currently being used in the room, making sure that it is not near sources of heat (ovens, fireplaces, stoves, etc. ) that could raise the internal temperature of the tank above 50C. Installation of Built-in Cooktops The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. The wall in direct contact with the back panel of the cooker must be made of non-flammable material. During operation the back panel of the cooker could reach a temperature of 50C above room temperature. For proper installation of the cooker, the following precautions must be taken: a) If the cabinet(s) located next to the cooktop are higher than the cooktop itself, the cabinet(s) must be installed at least 110 mm from the edge cooktop; b) Hoods must be installed in accordance with the instructions contained in the installation manual for the hoods themselves, and no less than 650 mm from the cooktop; c) The cabinets installed next to the hood must be located at a height of at least 420 mm from the top, (as shown in Fig. C). In a chimney stack or branched flue. (exclusively for cooking appliances) Directly to the Outside b) The room must also allow for the influx of the air needed for proper combustion. The flow of air for combustion purposes must not be less than 2 m/h per kW of installed capacity. The supply of said air can be effected by means of direct influx from the outside through a duct with a inner cross section of at least 100 cm which must not be able to be accidentally blocked. Those appliances which are not fitted with a safety device to prevent the flame from accidentally going out must have a ventilation opening twice the size otherwise required, i. e. Important: To insure that the appliance operates safety, the gas is regulated correctly and your appliance lasts over time, make sure that gas pressure levels comply with the indications given in Table 1, ?Nozzle and Burner Specifications?. Gas Connection to Non-flexible Pipe (copper or steel) Connection to the gas source must be done in such a way as to not create any stress points at any part of the appliance. 6 55 m m Fastening Clamps - Assembly Diagram Clamp Position for H=30mm top Clamp Position for H=20mm top Back N. B: Use the clamps contained in the "accessory kit. " The appliance is fitted with an adjustable, "L" shaped connector and a gasket for the attachment to the gas supply. Should this connector have to be turned, the gasket must be replaced (supplied with the appliance). The gas feed connector to the appliance is a threaded, male 1/2" connector for round gas pipe. Gas Connection to Flexible Steel Pipe The gas feed connector to the appliance is a threaded, male 1/2" connector for round gas pipe. Only use pipes, tubes and gaskets that comply with current safety codes. The maximum length of the flexible pipes must not exceed 2000 mm. Once the connection has been made, ensure that the flexible metal tube does not touch any moving parts and is not crushed. Check the Seal Once the appliance has been installed, make sure all the connections are properly sealed, using a soapy water solution. [. . . ] , , Merloni Elettrodomestici, : - . . - : 3. ; (, ); ; , / ; ; ; ( ) ; , . - , : - ; - (, , . . ); - ; - ( ). : - : - ; - : - ( ); - ; 11 - . [. . . ]