User manual HOTPOINT CJ65S G17

[. . . ] 13 Operating Instructions COOKER RS ÐÓÑÑÊÈÉ, 1 GB English, 13 Contents Positioning and levelling Electrical connection Gas connection Adapting to different types of gas Technical data Table of burner and nozzle specifications Installation, 14-17 Overall view Control panel Description of the appliance, 18 CJ 65S G17 RU /HA Using the hob Using the oven Oven cooking advice table Start-up and use, 19-21 General safety Disposal Respecting and conserving the environment Precautions and tips, 22 Switching the appliance off Cleaning the appliance Replacing the oven light bulb Gas tap maintenance Assistance Care and maintenance, 23 Installation GB  Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance.  Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved. [. . . ]  Be careful of the spark plug wires and the thermocouple tubes.  After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one that corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres).  Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet hose in accordance with current national regulations relating to “regulators for channelled gas”. The glass lid can break in if it is heated up. Turn off all the burners and the electric plates before closing the lid. CJ 65S G17 RU /HA 17 Description of the appliance GB Overall view Glass cover* Gas burner Hob grid Control panel Containment surface for spills GUIDE RAILS for the sliding racks position 5 position 4 position 3 position 2 position 1 Adjustable foot GRILL rack DRIPPING PAN rack Adjustable foot Control panel GRILL indicator light HOB BURNER control knobs OVEN control knob TIMER knob* * Only available in certain models. 18 Start-up and use Using the hob Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting . Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction. Only use position 1 in the oven when cooking with the rotisserie spit. Lighting the oven To light the oven burner, bring a flame or gas lighter close to opening F (see figure) and press the OVEN control knob while turning it in an anticlockwise direction until it reaches the MAX position. If the appliance is fitted with an electronic lighting device*, press and hold the OVEN control knob and turn it in an anticlockwise direction, towards the MAX position, until the burner is lit. If, after 15 seconds, the burner is still not alight, release the knob, open the oven door and wait for at least 1 minute before trying to light it again. If there is no electricity the burner may be lit using a flame or a lighter, as 19 GB described above.  The oven is fitted with a safety device and it is therefore necessary to hold the OVEN control knob down for approximately 6 seconds.  If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight the oven. Adjusting the temperature To set the desired cooking temperature, turn the OVEN control knob in an anticlockwise direction. Temperatures are displayed on the control panel and may vary between MIN (150°C) and MAX (250°C). Once the set temperature has been reached, the oven will keep it constant by using its thermostat. Grill By turning the OVEN control knob in an clockwise direction until it reaches the position, the infrared ray grill is activated. [. . . ] If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. We recommend that the oven is not used until the seals have been replaced. GB Cleaning the appliance  Never use steam cleaners or pressure cleaners on the appliance. • The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. [. . . ]