User manual HOTPOINT CM TDC DSL0

[. . . ] Turn unit off and unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. To disconnect, turn unit off, grasp plug, and pull out from wall outlet. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Return the appliance to an authorized service facility for examination, repair, or electrical or mechanical adjustment. [. . . ] insert the carafe on warming plate horizontally. Pressing the switch down, the indicator will be illuminated. Note: during brewing process you may remove the carafe to serve for duration of not exceeding 30 seconds, and the coffee maker can stop dripping automatically. If the serve time exceeds 30 seconds the coffee will overflow the funnel. Upon completion of brewing coffee, that is one minute later after the coffee stops dripping out, you can remove the carafe, pour and serve. Note: the brewed coffee you get will be slightly less than the water you have added as some water is absorbed by coffee powder. DO NOT touch cover, warming plate and so on when operating as they are very hot. When the process is finished, if you do not want to serve immediately, keep the switch on, the coffee can be kept warm in the warming plate for 40 minutes and the appliance will be cut off automatically after 40 minutes. For an optimum coffee taste, serve it just after brewing. Always turn the coffee maker off and disconnect the power supply after use. BEFORE THE FIRST USE Check that all accessories are complete and the unit is not damaged. Add clean water up to maximum level to brew several times without coffee powder according to the steps below, and then discard the water. Wash the detachable parts thoroughly with warm water. Note: Be careful when pouring the coffee out, otherwise you would be hurt as the temperature of coffee just finished is high CLEANING AND MAINTENANCE CAUTION: Always unplug the product from electrical outlet and allow the warming plate to cool completely before cleaning it. Never immerse the unit or power cord into water or any other liquid for cleaning 1. Clean all detachable parts after each use in hot, sudsy water. Wipe the product’s exterior surface with a soft, damp cloth to remove stains. Water droplets may buildup in the area above the funnel and drip onto the product base during brewing. To control the dripping, wipe off the USING YOUR COFFEE MAKER 1. Open the top lid and fill the water tank with cold drinking water. The water level should not exceed MAX level as indicated on water gauge. Put the funnel into funnel holder, then place the filter in the funnel, and make sure it is assembled correctly. [. . . ] Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. HINTS FOR GREAT-TASTING COFFEE Note: a clean coffee maker is essential for making great-tasting coffee. [. . . ]