User manual HOTPOINT CP 059 MT

[. . . ] CP 059 MT(X) UK Cooker maxioven Instructions for use end installation Congratualtions on choosing an ARISTON appliance, which you will find is dependable and easy to use. We recommend that you read this manual for best performance and to extend the life of your appliance. Thank you. SAFETY PRECAUTIONS THESE INSTRUCTIONS ARE ONLY VALID FOR THE COUNTRIES OF DESTINATION WHOSE SYMBOLS ARE SHOWN IN THE BOOKLET AND ON THE APPLIANCE RATING PLATE. 1. This appliance has been designed for private, nonprofessional use in normal dwellings. [. . . ] Keeping the 2 lower arms “A” raised, now pull out the door as shown in figure 4. FIG. 4 • Oven exterior: • Only clean the appliance when the oven is cold. • The steel parts and especially the areas with the screenprinted symbols should not be cleaned with solvents or abrasive detergents. It is advisable to use only a damp cloth with lukewarm water and washing up liquid. Stainless steel may remain stained if in long-term contact with very calcareous water or aggressive detergents (containing phosphorus). It is therefore always necessary to rinse and dry all surfaces thoroughly after cleaning. Adjusting the clock (At installation, after power failures, clock in advance or behind). Select manual mode by pressing key , adjust the hour and minutes using the and . Manual oven mode (Programming excluded) Press the key ; and the oven is switched on, the AUTO symbol goes out and the (oven on) symbol comes on. This operation erases any set programme. Semi-automatic oven mode 1st example: start in manual cooking mode - programmed cooking time. • Put the food to be cooked in the oven. • Press the key (duration) and adjust the cooking time using the and keys: the oven switches on, the AUTO and (oven on) symbols light up. • Turn the selector and the thermostat knobs onto the required function and temperature respectively. • At the end of the set cooking time, the oven is (oven on) automatically switched off, the symbol goes out and the AUTO symbol blinks; an acoustic signal sounds. 2nd example: start with manual cooking mode - end with programmed cooking mode. • Put the food to be cooked in the oven. • Press the key (end of cooking) and adjust the end of cooking time using the and keys: the oven switches on, the AUTO and symbols light up. • Turn the selector and the thermostat knobs onto the required function and temperature respectively. • At the end of cooking, the oven is automatically switched off, the symbol (oven on) goes out and the AUTO symbol blinks; an acoustic signal sounds. Automatic oven mode (programmed cooking duration and end) • Put the food to be cooked in the oven. • Press the key (Duration) and adjust the cooking time using the and keys: the AUTO and (oven on) symbols light up (the oven switches on). [. . . ] Also check that the connecting pipe cannot come into contact with moving parts which could damage or crush it. Make sure that the natural gas pipe is adequate for a sufficient supply to the appliance when all the burners are lit Important: A pressure regulator, in compliance with the standards in force, must be inserted when connecting to a liquid gas supply (in a cylinder). Adaptation to a different type of gas If the hob is to be converted for use with a type of gas other than that for which it was set in the factory (indicated on the label to be found on the hob), the burner nozzles should be replaced as follows: • Remove the pan supports and the burners. • Unscrew the nozzles “A” (fig. 9) using a 7 mm socket wrench and replace them with the ones which have a diameter suitable for the type of gas to be used, according to the table 1 "burners and nozzles specifications). • On completing the operation, replace the old rating label with the one showing the new type of gas; the sticker is available from our Service Centres. A fig. 9 Adjusting the low flame · Put the tap to the low flame position; · Remove the tap knob and turn the adjusting screw, situated inside of the tap stem (fig. 10), using a screwdriver (loosening the screw increases the height of the flame, tightening decreases it). [. . . ]