User manual HOTPOINT CP 649 MT

[. . . ] CP 649 MT UK Cooker maxioven Instructions for use end installation Congratualtions on choosing an Officina STAR appliance, which you will find is dependable and easy to use. We recommend that you read this manual for best performance and to extend the life of your appliance. Thank you. SAFETY PRECAUTIONS THESE INSTRUCTIONS ARE ONLY VALID FOR THE COUNTRIES OF DESTINATION WHOSE SYMBOLS ARE SHOWN IN THE BOOKLET AND ON THE APPLIANCE RATING PLATE. 1. This appliance has been designed for private, nonprofessional use in normal dwellings. [. . . ] When the light alternately comes on and goes out, it means that the thermostat is working properly to maintain the oven temperature. MAINTENANCE AND CLEANING Before cleaning your oven, or performing maintenance, disconnect it from the power supply. To extend the life of your oven, it must be cleaned frequently, keeping in mind that: • The self-cleaning panels (if present) and the enameled parts should be washed with warm water - abrasive powders and corrosive substances should be avoided; • The inside of the oven should be cleaned immediately after use with warm water and soap; the soap should be rinsed away and the interior dried thoroughly; • Stainless steel can be stained if it remains in contact with agressive detergents (containing phosphorus) or water with a high lime content. We recommend that you rinse these parts thoroughly and dry them well after cleaning. It is also a good idea to dry any water spills; • Never line the bottom of the oven with aluminium foil because the buildup of heat will not only impede the cooking process, but could also damage the enamel. Replacing the Lamp in the Oven • Cutoff the supply of power to the oven by turning off the omni-polar switch connecting it to the mains, or by removing the plug if it is accessible; • • Unscrew the glass cover attached to the lamp holder; Unscrew the lamp and replace it with another high-temperature lamp (300°C) with the following characteristics: - Voltage: 230/240 V - Wattage: 15W - Socket: E14 Remount the glass cover and reconnect the appliance to the power supply. • 4 INSTRUCTIONS FOR USE The electronic programmer has the function of automatically switching on the oven (at the required time) and switching it off at the end of the set cooking time. The 4 figure luminous display showing the actual time and the programming times, also shows the current state of the oven by means of the following symbols: Oven on Minute minder Automatic programme AUTO Point • (this divides the hour from the minutes on the display) All the functions may be programmed for a total of 23 h and 59 min. Adjusting the clock (At installation, after power failures, clock in advance or behind). Select manual mode by pressing key , adjust the hour / . and minutes using the Manual oven mode (Programming excluded) Press the key ; and the oven is switched on, the AUTO symbol goes out and the (oven on) symbol comes on. This operation erases any set programme. Semi-automatic oven mode 1st example: start in manual cooking mode - programmed cooking time. • Put the food to be cooked in the oven. key (duration) and adjust the cooking time • Press the using the et keys: the oven switches on, the AUTO and (oven on) symbols light up. • Turn the selector and the thermostat knobs onto the required function and temperature respectively. • At the end of the set cooking time, the oven is automatically switched off, the symbol (oven on) goes out and the AUTO symbol blinks; an acoustic signal sounds. 2nd example: start with manual cooking mode - end with programmed cooking mode. • Put the food to be cooked in the oven. • Press the key (end of cooking) and adjust the end of cooking time using the et keys: the oven switches on, the AUTO and symbols light up. • Turn the selector and the thermostat knobs onto the required function and temperature respectively. • At the end of cooking, the oven is automatically switched symbol (oven on) goes out and the AUTO off, the symbol blinks; an acoustic signal sounds. Automatic oven mode (programmed cooking duration and end) • Put the food to be cooked in the oven. (Duration) and adjust the cooking • Press the key time using the et keys: the AUTO and (oven on) symbols light up (the oven switches on). Quantity Temperature Time from bottom kg . [. . . ] Also check that the connecting pipe cannot come into contact with moving parts which could damage or crush it. Make sure that the natural gas pipe is adequate for a sufficient supply to the appliance when all the burners are lit Important: A pressure regulator, in compliance with the standards in force, must be inserted when connecting to a liquid gas supply (in a cylinder). Adaptation to a different type of gas If the hob is to be converted for use with a type of gas other than that for which it was set in the factory (indicated on the label to be found on the hob), the burner nozzles should be replaced as follows: • Remove the pan supports and the burners. • Unscrew the nozzles “A” (fig. 7) using a 7 mm socket wrench and replace them with the ones which have a diameter suitable for the type of gas to be used, according to the table 1 "burners and nozzles specifications). [. . . ]