User manual HOTPOINT CP9VP6 DE /HA

[. . . ] 12 Operating Instructions COOKER GB DE Deutsch, 1 GB English, 13 ES Espanol, 25 Contents Caution, 14-15 INSTRUCTIONS FOR THE INSTALLER, 16 Electrical connection, 17 TECHNICAL FEATURES NL Nederlands, 37 Description of the appliance, 18 OPERATING INSTRUCTIONS, 19 MULTIFUNCTIONAL ELECTRIC OVEN, 20 CP9VP6 DE/HA TIMER (ELECTRIC OVEN), 21 CLEANING AND MAINTENANCE, 22-23 COOKING ADVICE, 24 Caution G B 1 This appliance was designed for domestic use inside the home. 2 Before using the appliance, please read this instruction booklet carefully as it contains important information regarding the safe installation, operation and maintenance of the cooker. Keep this booklet in a safe place so that, if necessary, it may be consulted at a later date. 3 After the packaging has been removed, make sure that the appliance is intact and has not been damaged in any way. [. . . ] Before connecting the appliance to the power supply, make sure that: • The modulating valve and the electricity supply can withstand the maximum power of the appliance (see the data plate for details); • The electricity supply system is earthed correctly, in compliance with current laws and regulations; • The power socket or omnipolar switch may be reached easily once the hob has been installed. 11 V 1 1 2 3 4 5 • Secure the power supply cable by fastening the cable clamp screw, then put the cover back on. 5 mm² *Application of the simultaneity coefficient in compliance with the relevant standard. 17 Description of the appliance G B 20 60 2500W/1000W 60 0 2000W/1000W A B C D E F G H I Heating element Heating element Radiant/halogen heating element Residual heat indicator lights Hotplate selection controls Thermostat Function selector Electronic timer Electric oven operation indicator light 18 OPERATING INSTRUCTIONS Description of the heating elements The radiant elements “A-B-C” consist of circular heating elements. These become red a few seconds after they have been switched on. They are extremely easy to use because they are similar to the other heating elements. Control knobs Each cooking zone is fitted with a control knob “E”, which can be used to continuously adjust the temperature intensity level to values between a minimum of 1 and a maximum of 12. Table1 lists the correspondences between the positions indicated on the knob and the use for which the hotplates are recommended. The “A-B” hotplate control knob usually only activates Residual heat indicator light (D) This indicates that one or more cooking zones are at a temperature greater than 60°C, even after the cooking zones have been switched off. The hob is fitted with 4 residual heat indicator lights, one for each cooking zone. Advice for the operation of the ceramic glass hob To achieve the best results using your hob, there are several basic suggestions which should be taken into account while cooking or preparing food. • Use pans with a flat base so as to ensure the pan adheres properly to the cooking zone. If you wish to switch the light on without activating any of the heating elements, set the thermostat knob to 0°C. Indicator light “I” This indicates the heating-up phase of the oven is underway; as soon as the inside of the oven reaches the set temperature the light switches off. At this point the indicator light will begin switching on and off intermittently; this shows that the thermostat is operating correctly in order to maintain a constant temperature inside the oven. Spit - Rotisserie This accessory should only be used when cooking with the grill. Proceed as follows: thread the meat you wish to cook onto the rod positioned across the oven lengthwise, fixing it in place with the adjustable forks supplied (fig. 2b) in the relevant holes in dripping pan “E”, rest the groove on the rod in slot “C” and use the guide rail to place the rack in the lowest position in the oven; next position the rod in the rotisserie spit hole, sliding the groove forwards to slot “D”. Activate the grill and rotisserie spit by turning knob “H” on the commutator to the positions displaying the (grill), symbols. (maxigrill) or (maxigrill with fan) (grill), (maxigrill), 0 0) Off 2) Upper + lower heating elements 3) Lower heating element 4) Upper heating element 5) Grill heating element 6) Maxigrill heating element 6) Maxigrill heating elements + fan 7) Lower heating elements + fan 8) Circular heating element + fan 9) Quick defrosting After selecting the cooking function, set thermostat knob “F” to the desired temperature. For normal cooking procedures using conventional methods (roasts , biscuits , etc. ), use the function (heat from above + below). [. . . ] 6-7): • Open the door fully and lift up the two small levers “B” (fig. 6); • Now, when the door is closed slightly, it can be lifted out by removing hooks “A” as shown in figure 7. FIGURE 6 To replace the door: FIGURE 7 • With the door in an upright position, insert the 2 hooks “A” into the vents; • Make sure that slot “D” is perfectly fastened to the edge of the vent (move the door forwards and backwards slightly); • Keep the door completely open, shift the 2 levers “B” downwards, then close the door. 22 Replacing the oven light Make sure that the equipment is not connected to the electricity supply. [. . . ]