User manual HOTPOINT E2BL 19303 F

[. . . ] This is a separate part of the polystyrene base and should be removed with the base. IMPORTANT check when unpacking your machine. Check whether the washer-dryer has been damaged during transport. If this is the case, do not install it and contact your retailer. [. . . ] The desired drying cycle type may be set by pressing the DRY button once or several times. Two options are available: A - Based on the how damp the clothes are once they have been dried: Iron: suitable for clothes which will need ironing afterwards. the remaining dampness softens creases, making them easier to remove. Hanger: ideal for clothes which do not need to be dried fully. Cupboard: suitable for laundry which can be put back in a cupboard without being ironed. Extra: suitable for garments which need to be dried completely, such as sponges and bathrobes. B - Based on a set time period: between 20 and 180 minutes. To exclude the drying phase press the relevant button until the text OFF appears on the display. If your laundry load to be washed and dried is much greater than the maximum stated load, perform the wash cycle, and when the cycle is complete, divide the garments into groups and put some of them back in the drum. At this point, follow the instructions provided for a “Drying only” cycle. Repeat this procedure for the remainder of the load. The corresponding indicator light will become green, remaining lit in a fixed manner, and the door will be locked (the DOOR LOCKED symbol will be on). During the wash cycle, the name of the phase in progress will appear on the display. To change a wash cycle while it is in progress, pause the washer-dryer using the START/ PAUSE button (the START/PAUSE indicator light will flash slowly in an orange colour); then select the desired cycle and press the START/PAUSE button again. To open the door while a cycle is in progress, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted. This will be indicated by the text “END OF CYCLE” on the display; when the DOOR LOCKED symbol switches off the door may be opened. Open the door, unload the laundry and switch off the machine. If you wish to cancel a cycle which has already begun, press and hold the button. The cycle will be stopped and the machine will switch off. Wash cycles and functions Table of wash cycles Description of the wash cycle CLEANING PLUS Max. Cycle speed Drying Fabric load Wash softener (kg) duration (rpm) 1600                                        6 6 10 10 10 5 5 1 2. 5 4 1 7 5 2. 5 10 10 10 The duration of the wash cycles can be checked on the display. Wash cycles GB Anti Stain (1st press of the button) Anti Stain Quick (2nd press of the button) Cottons (Standard Cotton 60°) (1) (1st press of the button): heavily soiled whites and delicate colours. Cottons (Standard Cotton 40°) (2) (2nd press of the button): lightly soiled whites and delicate colours. [. . . ] This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. This guarantee is subject to the following conditions: - - - - - - - The appliance has been installed and operated correctly and in accordance with our operating and maintenance instructions. The appliance is used only on the electricity or gas supply printed on the rating plate. The appliance has been used for normal domestic purposes only. [. . . ]