User manual HOTPOINT E2BLH 19213 F O3

[. . . ] Switching off the electricity Clean the filter after each cycle Check the drum after each cycle Empty the Water Container after each cycle Cleaning the Heat Pump Filter Cleaning the dryer !Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works Troubleshooting, 53 Service, 54 Spare parts Disposal 37 Important Information For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter – You MUST Clean the fluff filter after every drying cycle. 2 GB Failure to clean the filter after every drying cycle will affect the drying performance of your machine – It will take longer to dry and as a result will use more electricity during drying. Water Container – You must empty the water container after every drying cycle. [. . . ] gB 45 GB Programmes Table !If the On/Off light is not lit; Press the On/Off Button Programme What it does Brief programme (approximately 10 minutes) that softens fibres of clothing that is ready for ironing. 20 min cool programme to air your clothes Dries: your Cotton clothes. Load 6 kg (with Low Heat option) Dries your shirt. This is not a drying programme (see previous page). Choose Sensor Dry or Timed Dry (see next page). Choose Sensor Dry or Timed Dry (see next page). Choose Sensor Dry or Timed Dry (see next page). Sensor Dry option, automatic drying: Damp dry , Iron dry , Hanger Plus , Hanger dry , Light dry , Cupboard dry , Ready to Wear . Sensor Dry option, automatic drying: , Hanger Plus , Hanger dry Damp dry , Iron dry , Light dry , Cupboard dry . Sound or Crease care Sensor Dry option, automatic drying: Damp dry , Iron dry , Hanger Plus , Hanger dry , Light dry , Cupboard dry , Ready to Wear . To change programme press Start/Pause Button to pause the programme, the light flashes Amber, select new programme and any option, the light will then flash green. Press the Start/ Pause Button and the new programme will start. €¢ Option Buttons/ Lights These buttons are used to customise the selected programme to your requirements. Not all options are available for all programmes (see Start and Programmes). If an option is not available and you press the button, the buzzer will beep three times. If the option is available there will be one beep and the option light next to the button lights to confirm the selection. €¢ ECO Light This light is illuminated when you select programme options that will use less energy than the default setting. Examples are if you choose an Automatic or sensing programme or use a timed dry setting less than the default time. This light does not indicate that the optimum setting for energy use has been selected; it only shows you that your selected options will use less energy. €¢ Progress ( Drying, Cool tumble, ) Lights The Progress lights show you the status of the programme. At each stage of the programme the corresponding light turns on. [. . . ] If any other number is shown; Note down the number and contact the service centre (see Service). • The dryer is in ‘Demo’ mode. Press and hold both the On/Off and Start/Pause buttons for 3 seconds. The display will show “dOn” for 3 seconds and then the dryer will resume normal operation. [. . . ]