User manual HOTPOINT ECOT7F 1292 EU

[. . . ] If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine. electric and water connections Connecting the water inlet hose 1. Connect the supply pipe by screwing it to a cold water tab using a ¾ gas threaded connection (see figure). Before performing the connection, allow the water to run freely until it is perfectly clear. [. . . ] wASH CYCLE knob: programmes the wash cycles. During the wash cycle, the knob does not move. SPIN SPEED button: sets the spin speed or exclude the spin cycle completely (see “Personalisation”). TEMPERATURE button: sets the temperature or the cold wash cycle (see “Personalisation”). DISPLAY: indicates the time remaining for the selected wash cycle and, if a delayed start has been programmed, the time remaining until the start of the wash cycle. CONTROL PANEL LOCK button with indicator light: activates or deactivates the control panel lock. FUNCTION buttons with indicator light: used to select the available functions. The indicator light corresponding to the selected function will remain lit. WASH CYCLE PROGRESS indicator lights: used to monitor the progress of the wash cycle. The illuminated indicator light shows which phase is in progress. DOOR LOCKED indicator light: indicates whether the door may be opened or not (see next page). 1, 14 52, 5 195’ Mix 15’: to refresh lightly soiled garments quickly (not suitable 5 for wool, silk and clothes which require washing by hand). 11 Cottons 12 Synthetics 13 Fast Wash Partials wash cycles A Rinse B Spin C Pump out  -  - The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. 1) Test wash cycle in compliance with directive 1061/2010: set wash cycle 2 with a temperature of 60°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 60°C. The actual washing temperature may differ from the indicated value. 2) Test wash cycle in compliance with directive 1061/2010: set wash cycle 3 with a temperature of 40°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 40°C. The actual washing temperature may differ from the indicated value. For all Test Institutes: 2) Long wash cycle for cottons: set wash cycle 3 with a temperature of 40°C. 3) Long wash cycle for synthetics: set wash cycle 4; with a temperature of 40°C. [. . . ] To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. Bleach cycle Bleaching may only be performed in conjunction with wash cycles 2, 3, 4, 6, 10, A. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be not solved easily using the following list. gB Problem: The washing machine does not switch on. [. . . ]