User manual HOTPOINT ENTM 182A1 F

[. . . ] Actual water consumption depends on how the appliance is used. 17 Precautions and advice EN This appliance was designed and manufactured in compliance with international safety standards The following information has been provided for safety reasons and should therefore be read carefully. Keep this instruction manual in a safe place for future reference. If the appliance is sold, given away or moved, please ensure the manual is kept with the machine. [. . . ] - The machine will switch off automatically during long periods of inactivity in order to minimise electricity consumption. AUTO WASH CYCLES*: some models of dishwasher are equipped with a special sensor which can be used to assess the level of soiling and automatically select the most efficient and economic wash cycle accordingly. The duration of the auto wash cycles may vary due to the operation of the sensor. Introduce the detergent into the dry dispenser “B” only. Place the amount of detergent for pre-washing directly inside the tub. When measuring out the detergent refer to the Table of wash cycles to add the proper quantity. Compartment B comprises a level showing the maximum quantity of liquid or powder detergent that can be added to each cycle. Remove detergent residues from the edges of the dispenser and close the cover until it clicks. Close the lid of the detergent dispenser by pulling it up until the closing device is secured in place. The detergent dispenser automatically opens up at the right time according to the wash cycle. If all-in-one detergents are used, we recommend using the TABS option, because it adjusts the cycle so that the best washing and drying results are always achieved. no detergent Wash cycle Options Approximate duration of wash cycles Eco 50°* Delayed start – Tabs Half Load – Extra Dry 3:10’ Auto Intensive Yes Delayed start – Tabs Half Load – Extra Dry 2:30’ Auto Normal Yes Delayed start – Tabs Half Load – Extra Dry 2:00’ Auto Fast No Delayed start – Tabs - Half Load 1:00’ Delicate Yes Delayed start – Tabs Half Load – Extra Dry 1:40’ Express 30’ No Delayed start – Tabs 0:30’ Soak No Delayed start Half Load 0:12’ ** Quantity of pre-washing detergent. ** Data is obtained by recording values when the appliance is operational and loaded with user crockery. 25 Special wash cycles and Options EN Notes: Optimum performance levels when using the “Fast" and "Express 30’” cycles can be achieved by respecting the specified number of place settings. To reduce consumption even further, only run the dishwasher when it is full. Note for Test Laboratories: for information on comparative EN testing conditions, please send an email to the following address: ASSISTENZA_EN_LVS@indesitcompany. Com If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and detergent. Select the wash cycle and press the HALF LOAD button: the indicator light will illuminate. Press the HALF LOAD button to deselect this option. half load* Remember to halve the amount of detergent. Wash options* The OPTIONS may only be set, changed or reset after the wash cycle has been selected and before the Start/ Pause button has been pressed. Only the options whic are compatible with the type of wash cycle set may be selected. [. . . ] € The dishes are rattling against each other or against the sprayer arms. € An excessive amount of foam has been produced: the detergent has not been measured out correctly or it is not suitable for use in dishwashers (see Start-up and use). The dishes and glasses are covered • The level of the refined salt is low or the dosage setting is not suited to the hardness in a white film or limescale deposits. € The lid on the salt dispenser is not closed properly. [. . . ]