User manual HOTPOINT ENXTL 19212 F

[. . . ] Switching off the electricity Clean the filter after each cycle Check the drum after each cycle Empty the Water Container after each cycle Cleaning the Heat Pump Filter Cleaning the dryer !Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works Troubleshooting, 71 Service, 72 Spare parts Disposal 55 Important Information For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter – You MUST Clean the fluff filter after every drying cycle. 2 GB Failure to clean the filter after every drying cycle will affect the drying performance of your machine – It will take longer to dry and as a result will use more electricity during drying. Water Container – You must empty the water container after every drying cycle. [. . . ] 5 kg and no individual item should be greater than 600 g. Heat & Enjoy • The Heat & Enjoy cycle helps to heat towels & bathrobes for a warm sensation after a bath or a shower. It is also useful for warming clothes before dressing during winter. The cycle heats the clothes up to 37° (the body temperature) and keeps the same temperature for a maximum of 4 hours or until the user stops the cycle by opening the door. Note: during this programme a icon rotates in the display until the temperature target is reached at which point the dryness level icon flashes. gB 63 Programmes Table GB !If the On/Off light is not lit; Press the On/Off Button Programme What it does Brief programme (approximately 10 minutes) that softens fibres of clothing that is ready for ironing. 20 min cool programme to air your clothes Dries: your Cotton clothes. Load 6 kg (with Low Heat option) Dries your shirt. This is not a drying programme (see previous page). Choose Sensor Dry or Timed Dry (see next page). timed Drying (220 , 180 , 150 , 90 , 60 or 40 minutes) Options available Sound or Crease care Consult suggested drying times (see Laundry). The last few minutes of these programmes is the cool tumble phase. For the best performance do not open the door before the cycle has finished. Press the Start/ Pause Button and the new programme will start. €¢ Option Buttons/ Lights These buttons are used to customise the selected programme to your requirements. Not all options are available for all programmes (see Start and Programmes). If an option is not available and you press the button, the buzzer will beep three times. If the option is available there will be one beep and the option light next to the button lights to confirm the selection. €¢ ECO Light This light is illuminated when you select programme options that will use less energy than the default setting. Examples are if you choose an Automatic or sensing programme or use a timed dry setting less than the default time. This light does not indicate that the optimum setting for energy use has been selected; it only shows you that your selected options will use less energy. [. . . ] €¢ The dryer has gone into standby mode to save power. This occurs if you have left the dryer on or have had a power cut. It occurs after 30 minutes: - if you leave the dryer without starting a programme; - after your drying programme has finished. Press and hold the ON/OFF button until the dryer reactivates 71 Service 04/2013 - Xerox Fabriano GB Heat Pump System This dryer is fitted with a sealed heat pump system to dry your clothes. [. . . ]