User manual HOTPOINT ENXTLH 19202 F

[. . . ] U moet doorgeven: • het type storing • het model apparaat (Mod. ESTAMOS A SU SERVICIO - modello - model - modèle - modell - model - modelo - modelo - model - model - μοντέλο - numero di serie - serial number - numéro de série - modellnummer - serienummer - número de serie - número de série - numer seryjny - număr de serie - αριθμός σειράς 4 Antes de contactar a AssistÍncia técnica: • Verifique se pode resolver sozinho a anomalia (veja as Anomalias e Soluções). - modello - model - modèle - modell - model - modelo - modelo - model - model - μοντέλο - numero di serie - serial number - numéro de série - modellnummer - serienummer - número de serie - número de série - numer seryjny - număr de serie - αριθμός σειράς 5 Descrizionedell’apparecchio Description of the appliance Pannello di controllo 1 Pulsante FUNZIONAMENTO CONGELATORE per regolare la temperatura del vano congelatore. Control panel 1 FREEZER OPERATION Button to regulate the temperature the freezer compartment. [. . . ] The compressor also starts each time the power supply is cut off whether voluntarily or involuntarily (blackout). FRUIT and VEGETABLE bin* The salad crispers fitted inside the fridge have been specially designed for the purpose of keeping fruit and vegetables fresh and crisp. Open the humidity regulator (position B) if you want to store food in a less humid environment like fruit, or close it (position A) to store food in a more humid environment like vegetable. 21 GB A A B B TEMPERATURE Indicator light*: to identify the coldest area in the refrigerator. Check that OK appears clearly on the indicator light (see diagram). If the word “OK” does not appear it means that the temperature is too high: set a lower temperature and wait approximately 10 hours until the temperature has been stabilised. Check the indicator light again: if necessary, readjust it following the initial process. If large quantities of food have been added or if the refrigerator door has been opened frequently, it is normal for the indicator not to show OK. Wait at least 10 hours before adjusting the REFRIGERATOR OPERATION knob to a higher setting. Food Care Zone * Area dedicated to the storage of fresh food, such as meat and fish. Thanks to the low temperature inside the compartment, the Food Care Zone extends the period of time for which the food can be stored, keeping it fresh for up to a week. Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: 1. set the FREEZER OPERATION knob on OFF; 2. Pull the plug out of the socket Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. € The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. * Varies by number and/or position, available only on certain models. 22 Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. € If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. The I Care function can be enabled to optimise energy consumption. Press and hold down the SPEED COOL and REFRIGERATOR OPERATION buttons simultaneously for at least 6 seconds to enable this function. [. . . ] € The appliance has been installed between cabinets that vibrate and make noise. € The internal refrigerant makes a slight noise even when the compressor is off. Troubleshooting If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list. € If the function I Care is not active (see section), the plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house. [. . . ]