User manual HOTPOINT ENXTM 19212 F

[. . . ] 3) Based on 280 standard cleaning cycles. Actual water consumption depends on how the appliance is used. 16 Precautions and advice This appliance was designed and manufactured in compliance with international safety standards The following information has been provided for safety reasons and should therefore be read carefully. Keep this instruction manual in a safe place for future reference. [. . . ] EN SELECT knob clockwise: align the notch in the knob with the number/symbol representing the desired wash cycle. The START/PAUSE indicator light will go on. Select the wash options* (see Special wash cycles and options. Start the cycle by pressing the Start/Pause button: a beep will sound* and the indicator light corresponding to the wash phase will go on to signal that the cycle has begun. At the end a few beeps * will signal the end of the wash cycle and the END indicator light will go on. Switch off the appliance by pressing the ON/OFF button, shut off the water tap and unplug the appliance from the electricity socket. Wait a few minutes before removing the crockery to avoid getting burnt. Unload the racks, beginning with the lower level. - The machine will switch off automatically during certain periods of inactivity in order to minimise electricity consumption. Changing a wash cycle in progress If a mistake was made in the wash cycle selection process, it is possible to change the cycle provided that it has only just begun: once the wash cycle has started, in order to change the wash cycle switch off the machine by pressing and holding the ON/OFF/Reset button. Switch it back on using the same button and select the desired wash cycle and options. The ECO wash cycle is the standard cycle to which the energy label data refers. It can be used to wash crockery with a normal soil level and is the most efficient cycle in terms of energy and water consumption for this type of crockery. Cycle for delicate items, which are more sensitive to high temperatures 35 gr/ml – 1 Tab 6. Fast cycle to be used for slightly dirty dishes (ideal for 2 place settings) 25 gr/ml – 1 Tab 7. Pre-wash while awaiting completion of the load with the dishes from the next meal. 24 Special wash cycles and Options Notes: Optimum performance levels when using the “Fast" and "Express 40’” cycles can be achieved by respecting the specified number of place settings. To reduce consumption even further, only run the dishwasher when it is full. Note for Test Laboratories: for information on comparative EN testing conditions, please send an email to the following address: ASSISTENZA_EN_LVS@indesitcompany. Com If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and detergent. Select the wash cycle and press the HALF LOAD button; the indicator light will go on. Press the HALF LOAD button again to deselect this option. [. . . ] • The appliance has not been plugged in properly. € The dishwasher door has not been shut properly. Strongly push the door until a “clacking” noise is T heard. The dishes and glasses are covered in a white film or limescale deposits. [. . . ]