User manual HOTPOINT EVO II 1200 PLT 52LT

[. . . ] M Washing machine Instructions for installation and use WAX 120 Quick guide Here are the 12 topics explained in this manual. Read, learn and have fun: you will discover many secret ways to get a better wash, more easily and making your washing machine last longer. 1. 10) Installation, after delivery or transport, is the most important operation for the correct functioning of your washing machine. That the electric system conforms to regulations; 2. [. . . ] Is the programmed start knob, in the correct position for those models concerned?For safety reasons, if the washing machine does not load water, it cannot start a wash cycle. select one of the symbols stop/reset , then switch it back on. If the knob continues to turn, call for assistance because it is showing an anomaly. But where did all the water go? Simple: with the new Indesit technology, you need less than half of it, to get good results on twice as much!This is why you cannot see the water through the door: because there is little, very little of it, to respect the environment yet without renouncing maximum cleanliness. And, on top of that, you are also saving electricity. The washing machine fails to fill with water. RIGHT Turn off the water supply after use. This will eliminate the possibility of leakage. Always leave the appliance door ajar to avoid bad odours. Clean the appliance’s exteriors gently. To clean the exteriors and the rubber parts of the appliance, always use a soft cloth dipped in warm and soapy water. WRONG Leave the washing machine plugged in while cleaning. Even during maintenance, the appliance should always be unplugged. Never use solvents or abrasives to clean the external and rubber parts of the washing machine. It is removable and can easily be cleaned by leaving it under running water. Go on holiday without thinking about her. Before leaving, always make sure that the washing machine is unplugged and that the water supply is turned off. Is the hose correctly connected to the tap?There could be work in progress in your building or street. If the water is very calcareous, or if work has recently been carried out on the water piping, the tap filter could be clogged with particles and debris. The tract of the rubber hose bringing water to washing machine must be as straight as possible. Make sure it is not squashed or kinked. The washing machine continuously fills and drains water. Is the drain hose positioned too low?It must be installed at a height ranging from 60 to 100 cm. Is the end of the hose immersed in water?Does the wall drainage system have a breather pipe? [. . . ] Never try to do this alone, because the appliance is very heavy. Before loading the washing machine, make sure the drum is empty. Never touch the washing machine when barefoot or with wet or damp hands or feet. Never use extensions or multiple plugs, which are particularly dangerous in humid environments. [. . . ]