User manual HOTPOINT FDG 8640 K FR

[. . . ] 2 Raccordement du tuyau de vidange Raccorder le tuyau d’évacuation, sans le plier, à un conduit d’évacuation ou à une évacuation 65 - 100 cm murale placés à une distance du sol comprise entre 65 et 100 cm ; ou bien l’accrocher à un évier ou à une baignoire, dans ce cas, fixer le support en plastique fourni avec l’appareil au robinet (voir figure). This symbol reminds you to read this instruction manual. GB GB English Contents Installation, 14-15 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Care and maintenance, 16 Cutting off the water and electricity supplies Cleaning the washer-dryer Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose FDG 8640 Precautions and advice, 17 General safety Disposal Opening the porthole door manually Description of the washer-dryer, 18-19 Control panel Display How to run a wash cycle or a drying cycle, 20 Wash cycles and options, 21 Table of programmes and wash cycles Wash options Detergents and laundry, 22 Detergent dispenser drawer Preparing the laundry Special wash cycles Load balancing system Troubleshooting, 23 Service, 24 13 Installation GB !This instruction manual should be kept in a safe place for future reference. [. . . ] dOOR LOCKED indicator light: The lit symbol indicates that the door is locked. To prevent any damage, wait until the symbol turns off before opening the door. To open the door while a cycle is in progress, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened. 19 How to run a wash cycle or a drying cycle GB 1. Press the button; the START/PAUSE indicator light will flash slowly in a green colour. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes and wash cycles on the following page. Pull out the detergent dispenser drawer and pour the detergent into the relevant compartments as described in “Detergents and laundry”. Use the WASH CYCLE SELECTOR knob to select the desired wash cycle. A temperature and spin speed is set for each wash cycle; these values may be adjusted. The duration of the cycle will appear on the display. Use the relevant buttons: Modify the temperature and/or spin speed. The machine automatically displays the maximum temperature and spin speed values set for the selected cycle, or the most recentlyused settings if they are compatible with the selected cycle. The temperature can be decreased by pressing the button, until the cold wash “OFF” setting is reached. The spin speed may be progressively reduced by pressing the button, until it is completely excluded (the “OFF” setting). If these buttons are pressed again, the maximum values are restored. Exception: if the 4 programme is selected, the temperature can be increased up to a value of 90°C (+ prewash). Setting the drying cycle The first time the button is pressed, the machine will automatically select the maximum drying cycle which is compatible with the selected wash cycle. Subsequent presses will decrease the drying level and then the drying time, until the cycle is excluded completely (“OFF”). Drying may be set as follows: A- Based on the desired laundry dryness level: Iron “A1”: suitable for clothes which will need ironing afterwards. The remaining dampness softens creases, making them easier to remove. Hanger “A2”: ideal for clothes which do not need to be dried fully. Cupboard “A3”: suitable for laundry which can be put back in a cupboard without being ironed. [. . . ] troubleshooting Your washer-dryer could occasionally fail to work. Before contacting the Technical Assistance Service (see “ Service”), make sure that the problem cannot be solved easily using the following list. GB Problem: Possible causes / Solutions: The washer-dryer does not switch • The appliance is not plugged into the socket fully, or not enough to make contact. The washer-dryer does not fill • The water inlet hose is not connected to the tap. [. . . ]