User manual HOTPOINT FH G IX/HA S

[. . . ] Years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. [. . . ] If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. This sticker is available from any of our Service Centres. If the gas pressure is different from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe in accordance with current National Regulations. 5 cm 58 l see data plate see data plate This appliance conforms to the following European Economic Community directives: 2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments - 2004/108/EEC dated 15/12/04 (Electromagnetic compatibility) and subsequent amendments - 93/68/EEC dated 22/07/93 and subsequent amendments. Unscrew the oven burner nozzle using the special socket spanner for the nozzles, or better still a 7 mm socket spanner, and replace it with a nozzle suited to the new type of gas (see Table 1). Replace all the parts, following the steps described above in the reverse order. When inserting the shelf make sure the backstop is at the rear of the cavity (see image). The oven is equipped with a safety device. After lighting the burner allow the gas to circulate until the safety thermocouple is heated by keeping the OVEN knob pressed in for about 6 seconds. Once the burner is lit, shut the oven door. To light the oven burner, press the OVEN knob in as far as possible and turn it anti-clockwise, setting it to position (keeping the oven door shut). The oven is equipped with a safety device. After lighting the burner allow the gas to circulate until the safety thermocouple is heated by keeping the OVEN knob pressed in for about 6 seconds. The electronic ignition device of the oven burner must not be activated for more than 15 seconds. If the burner fails to light after 15 seconds, stop pressing the OVEN knob, open the oven door and wait for at least one minute before you try to light the burner again. The cooking temperature is selected by matching the desired temperature with the reference mark on the control panel; the complete range of temperatures is shown below: Min ? 150 ?200 220 ? Max 140 145 230 240 The oven will automatically reach the temperature set, and the thermostat, which is controlled by the knob, will keep the temperature constant. Switching the oven on manually In the event of a power failure, the oven burner can be lit manually: 1. Hold a match or lighter near the burner hole as shown in the figure, press knob F (see figure) in fully and turn it anticlockwise, setting it to the Max position. To set the buzzer, turn the TIMER knob clockwise almost one complete revolution. Turn the knob anticlockwise to set the desired time: align the minutes shown on the knob with the indicator on the control panel. [. . . ] ? All accessories - with the exception of the sliding racks - can be washed like everyday crockery, and are even dishwasher safe. Never use steam cleaners or pressure cleaners on the appliance. Grip the door on the two external sides and close it approximately half way. Pull the door towards you, extracting it from its hinges (see diagram). [. . . ]