User manual HOTPOINT FO 87C/E IX AUS

[. . . ] Congratulations on choosing an Ariston appliance, which you will find is dependable and easy to use. We recommend that you read the instructions in this owner’s manual carefully before use for the best performance and to extend the life of your appliance, as it will provide you with all the instructions you require to ensure its safe installation, use and maintenance. Always keep this owner’s manual close to hand since you may need to refer to it in the future. Thank you. Close-up view A H G B D A C 8 F 7 A 9 1 2 3 4 5 6 A. [. . . ] By using the fan, the defrosting time is approximately halved. In the case of meat, fish and bread, it is possible to accelerate the process using the “multi-cooking” mode and setting the temperature to 80° - 100°C. Programming the cooking mode The cooking time and/or end cooking time can be programmed after the desired cooking mode has been selected. Programming the cooking time Press button 5 and then adjust the cooking time by turning knob C. Press the OK button to store the setting. The temperature selected (which can be adjusted using knob C) and the amount of time left until cooking is complete will be displayed alternately. Once this time is up, the word “end” will be displayed and a sequence of acoustic signals will be emitted to indicate that cooking is complete. • Press any button to silence the acoustic signal. • Turn knob B back to position 0 to remove the word “end” from the display. and a cooking time of 1 hour and 15 minutes is programmed. Cooking will stop automatically at 10:15 a. m. . and the end cooking time is set at 10:15 a. m. . Cooking will last 1 hour and 15 minutes. Delayed cooking programming Press button 5 and then adjust the cooking time by turning knob C. If these stains are difficult to remove, use special products available on the market. After cleaning, it is advisable to rinse thoroughly and dry. • the inside of the oven should preferably be cleaned immediately after use, when it is still warm, with hot water and soap; the soap should be rinsed away and the interior dried thoroughly. Avoid using abrasive detergents (for example cleaning powders, etc…) and abrasive sponges for dishes or acids (such as limescale-remover, etc…) as these could damage the enamel. If the grease spots and dirt are particularly tough to remove, use a special product for oven cleaning, following the instructions provided on the packet. • if you use your oven for an extended period of time, condensation may form. • there is a rubber seal surrounding the oven opening which guarantees its perfect functioning. Check the condition of this seal on a regular basis. If necessary, clean it and avoid using abrasive products or objects to do so. Should it become damaged, please contact your nearest After-sales Service Centre. [. . . ] A); • is 18 mm thick: use the first groove, which is factoryset (Fig. B); • is 16 mm thick: use the second groove (Fig. C) 23 mm. 595 mm. 567 mm. 558 mm . 595 5 mm. mm . . 545 mm . 24 mm N. B. : Installation in compliance with the consumption declaration m. B 23 mm. 575-585 mm. 595 mm. 595 mm. 567 mm. 558 mm . 45 . n mi 595 mm . . 545 mm . Fig. [. . . ]