User manual HOTPOINT H64IL9PAA S

[. . . ] Knapp för INSTÄLLNING AV TID 3 GB Assistance FI Huoltoapu Warning: The appliance is fitted with an automatic diagnostic system which detects any malfunctions. Malfunctions are displayed by messages of the following type: “F” followed by numbers. Call for technical assistance in the event of a malfunction. Never use the services of an unauthorised technician. [. . . ] During the first few hours of use there may be a smell of rubber which will disappear very quickly. A few seconds after the hob is connected to the electricity supply, a buzzer will sound. Types of noise during normal hob operation: • Buzz: due to the vibration of the metallic parts that make up the induction element and the pot; it is generated by the electromagnetic field required for heating and increases as the power of the induction element increases. € Soft whistle: heard when the pot placed on the heating zone is empty; the noise disappears once food or water is placed into the pot. € Crackle: produced by the vibration of materials on the bottom of the pot due to the flow of parasitic currents caused by electromagnetic fields (induction); can be more or less intense depending on the material making up the bottom of the pot, and decreases as the pot dimensions increase. € Loud whistle: heard when two induction elements of the same group function simultaneously at maximum power and/or when the booster function is set on the larger element while the other is auto-adjusted. Noise is reduced by decreasing the power level of the autoadjusted induction element; pot bottom layers made of different kinds of materials are among the main causes of this noise. When power is initially applied to the Cooktop, the touch control conducts a calibration process for the touch keys, which requires a low level of ambient light in the area of the touch keys. If during this calibration process excessive ambient lighting is detected the User Interface displays „FL” (Infrared Ambient Light Error) and the control calibration process is suspended. In order to rectify the process any lighting that could effect the calibration process should be switched off (e. The error will disappear when satisfactory ambient lighting is detected and the touch control calibration procedure will now complete satisfactorily. -The „FL” error can only be generated within approx 3s of initial power being applied to the cooktop. -We recommend that the user switches off all cooker hood lighting and lighting directed towards the cooktop when power is initially applied to the cooktop. -After the touch control has conducted its initial calibration process, (approx 3s) any cooker hood or other lighting can be switched on as normal and will not affect the operation of the touch control. Switching on the hob After connecting the hob to the electrical grid, the touch pannel might be automatically locked. To unclock the pannel press and hold the Control Panel Loock button . Button for To switch the hob on, press and hold the approximately one second. The cooktop is switched On when a beep sound is emitted and the cooking zones display shows the „0” 17 GB When the cooktop is off, after 5 sec. Without any error/ alarm or residual heat to display, the control switches Switching off the cooking zones To switch off a cooking zone touch(-)and (+) POWER selection buttons simultaneously. A beep sounds and the corresponding display shows “0”. In order to reduce power off the (KEYLOCK LED) consumption. As soon as we touch a key, the (KEYLOCK LED . [. . . ] € Do not place tea towels or pot holders over the oven handle. € Turn the SELECTOR knob to the “0” position. If the oven is too hot, the pyrolytic cycle may not start. The programme may only be started once the oven door has been closed. [. . . ]