User manual HOTPOINT HHDA 9.7 CB X/HA

[. . . ] € NEVER use the hood as a support, unless expressly instructed to do so. € The room must be adequately ventilated if the hood is used at the same time with other equipment burning gas or other fuels. If you sell, transfer or move the unit to another location, make sure to keep the manual with the product. Read the instructions carefully - they contain important installation, user and safety information. [. . . ] The manufacturer is not liable for any consequences of doing so. Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. The duct must be made of regulatory material. Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, GLASSs, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. Of exhaust tube (cm) 15/12 Power Halogen 25 W Halogen 20 W 2 x 25 W 2 x 20 W Voltage 230 V 12 V Cap G9 G4 Dimensions L40xØ14 L30xØ10 Please check the plate in order to verify the total absorption and the light absorption The model is in accordance with the following EU directives:: • “Low voltage” Directive 2006/95/EC (12-12-2006) • “EMC” Directive 2004/108/EC (15-12-2004) • UR Reference no. If you wish to use it as a filter unit, you must install the proper ACCESSORY KIT. Note: If supplied with the hood, the accessory active charcoal filter unit may already be installed. Instructions for transforming the hood from the ducted to the filter version are given in this manual (see “Filter version”). 18 GLASS controls Models with soft button keypad B Maintenance and care Caution!Before cleaning or servicing the unit, disconnect it from the mains by pulling the power plug or disconnecting the main circuit breaker. GB T1 T2 T3 T4 T5 T6 T1 Motor reset Press the button with the hood off to set speed 1. Pressing the button while the hood is in operation turns it OFF. First cleaning • Remove the protective film • Clean with a damp sponge and a little neutral soap • Rinse off with a damp cloth • Dry with a soft cloth; if the hood is stainless steel, dry along the metal's grain Periodic cleaning The hood must be cleaned frequently (at least as often as you service the grease filter), inside and out. Use a damp cloth and a neutral liquid detergent with lukewarm water. do not use abrasive or corrosive products. [. . . ] Electrical cable If the power cable is damaged, it can be replaced by the manufacturer or his technical service, to prevent any attendant risks. SCRAPPING The unit is marked for conformity with European Directive 2012/19/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that the unit is scrapped properly, the user contributes to safeguarding the environment and public health. If the hood is not working effectively: Check that: • the selected motor speed is sufficient to handle the amount of smoke and steam being produced. [. . . ]