User manual HOTPOINT HKID641B C

[. . . ] Indicates a hazardous situation which, if not avoided, could cause serious injury. All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of injury, damage and electric shocks due to incorrect use of the appliance. Make sure to comply with the following: - Use protective gloves to perform all unpacking and installation operations. - The appliance must be disconnected from the power supply before carrying out any installation operation. [. . . ] The lower part of the product must not be accessible after installation. Do not fit the separator panel if an undertop oven is installed. 20 mm 6-7 cm The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure. In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. If an undertop oven is installed, make sure the oven is equipped with a cooling system. Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them. To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance. EN7 ELECTRICAL CONNECTION Disconnect the appliance from the power supply. Installation must be carried out by qualified personnel who know the current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. The power cable must be long enough to allow the hob to be removed from the worktop. If the display shows , the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used, for example, to keep a dish warm or to melt butter. When the cooking zone cools down, the display goes off. If you are using a pot that is not suitable, not correctly positioned or not of the correct dimensions for your induction hob, the message “no pot” will appear in the display (see figure at side). In these situations it is recommended to reposition the pot on the hob surface until you find the position of operation. If no pot is detected within 60 seconds, the hob switches off. Fast boil function (Booster where it is available) This function, only present on some cooking zones, makes it possible to exploit the hob’s maximum power (for example to bring water to the boil very quickly). To activate the function, press the “+” button until “P” appears on the display. After 5 minutes’ use of the booster function, the appliance automatically sets the zone to level 9. FLEXI This function is used in case of big pots that the single zone can not satisfied, ex, fish, big pot for meat. In order to active the FLEXI/CONNEXTION ZONE, please press on + and - buttons simultaneously as shown in the picture below. [. . . ] - The appliance is used only on the electricity or gas supply printed on the rating plate. - Theappliancehasbeen used fornormal domesticpurposes only. - The appliance has not been altered, serviced, maintained, dismantled, or otherwiseinterferedwith by any personnot authorisedby us. - Any repair work must be undertaken by us or our appointed agent. [. . . ]