User manual HOTPOINT HNC 6.8 AB X/HA

[. . . ] € The room must be adequately ventilated if the hood is used at the same time with other equipment burning gas or other fuels • Extracted air must not be conveyed into a duct used for exhausting combustion fumes from gas or other fuel-fired equipment. • Observe all regulations in relation to air extraction. € NEVER cook food with an open flame under the hood; open flames will damage the filters and may cause fires. € Always supervise frying to make sure the heated oil does not catch fire. [. . . ] GB Electrical hook up The mains voltage must match that given on the ratings label inside the hood itself. If the hood has a power plug, connect the hood to an easily accessible regulatory power socket. If it does not (direct connection to the mains), or the socket is not easily accessible, install a two-pole regulatory switch to enable total disconnection from the mains in case of category III overvoltage, as required by the installation regulations. Always check that the mains cable is hooked up properly and check that it operates correctly before reconnecting the hood to the mains. Air exhaust (for ducted units) Connect the hood to a duct and wall exhaust hole of a diameter equal to that of the air outlet flange. Using a smaller diameter tube and exhaust hole reduces the extraction capacity of the hood and also increases its running noise. The manufacturer is not liable for any consequences of doing so. Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. This filter can NOT be washed or regenerated Disassembly: Remove the activated-carbon filter by B pressing the two front levers which secure it to the hood. T1 T2 T3 T4 T5 T6 T1 Motor reset Press the button with the hood off to set speed 1. Pressing the button while the hood is in operation turns it OFF. T2 Speed 1 Pressing the button sets the hood to speed 1. T3 Speed 2 Pressing the button sets the hood to speed 2. T4 Speed 3 Pressing the button sets the hood to speed 3. T5 Booster Pressing the button sets the hood to high speed. After 5 minutes, the hood returns to the previous speed; pressing a speed button (T2, T3 or T4) quits booster mode and sets the selected speed. T6 Lights ON/OFF Grease/odour filter warnings The T2 icon flashes to indicate that the grease filter is saturated, while T3 flashes to indicate that the odour filter is saturated, and if both are flashing then both filters are saturated. You must then clean/replace the grease filter (A) or odour filter (B) or both, accordingly (see “Maintenance and care”). To reset the filter counter: Hold down T5 for three seconds while the hood is on. [. . . ] If the hood is not working effectively: Check that: • the selected motor speed is sufficient to handle the amount of smoke and steam being produced. € the kitchen is adequately ventilated for the unit to take air in. € the charcoal filter is not exhausted (filter version). If the hood turns off during normal operation: Check that: • the unit is powered up. [. . . ]