User manual HOTPOINT HNP 6.5 CM X/HA

[. . . ] 10 disconnect it from the mains by pulling the power plug or disconnecting the main circuit breaker. Or persons with sensory or mental disability and lack of experience or familiarity, except under the supervision or instruction of a person responsible for their safety. In relation to the technical and safety measures to be employed in fumes extraction. And out (AT LEAST ONCE A MONTH, and in observance of the maintenance instruction given in this manual). [. . . ] 5 CM (AN)/HA Bulb (V) Bulb draw (W) Total draw (W) Halogen 2 x 25 160 Model code HNP 6. 5S CM (AN)/HA Bulb (V) Bulb draw (W) Total draw (W) Halogen 2 x 25 195 Model code HNP 6. 6 CM (OW)/HA Bulb (V) Bulb draw (W) Total draw (W) Filter or ducted?Note: If supplied with the hood, the accessory active Instructions for transforming the hood from the ducted to the Halogen 2 x 20 210 Halogen 2 x 25 220 Model code HRP 9. 8 CM (AN)/HA Bulb (V) Halogen Bulb draw (W) Total draw (W) 2 x 25 300 35 GB The hoods are conforming to the following EC Directives: HNP 9. 5S CM (AN)/HA T1 T2 T3 T4 T5 T6 T1 Motor reset Pressing the button while the hood is in operation turns it T2 Speed 1 Pressing the button sets the hood to speed 1. T3 Speed 2 Pressing the button sets the hood to speed 2. T4 Speed 3 Pressing the button sets the hood to speed 3. T5 Booster Pressing the button sets the hood to high speed. After 5 a speed button (T2, T3 or T4) quits booster mode and sets the selected speed. T6 Lights ON/OFF T1 T2 T3 T4 T5 The T2 saturated, while T3 A) B) or both, accordingly (see “Maintenance T1 Motor reset Pressing the button while the hood is in operation turns it T2 Speed 1 Pressing the button sets the hood to speed 1. T3 Speed 2 Pressing the button sets the hood to speed 2. T4 Speed 3 Pressing the button sets the hood to speed 3. T5 Lights ON/OFF Hold down T4 for three seconds while the hood is on. 5S CD X/HA HPS 60 IX/HA Hold down T4 for three seconds while the hood is on. GB B T1 T2 T3 T4 T5 T6 To set the operating mode of the hood, hold down T4 for 6 seconds. After a long beep, the type of installation displays: 1 Motor ON/OFF Press the button with the hood off to set speed 1. Pressing Ducted T2 Speed Pressing the button returns the hood to the previous speed. [. . . ] Replacing the bulbs Disconnect the unit from the mains and remove the grease Caution!Make sure the bulbs are cool before touching them. Extract the guard by prising it out with a small flat head screwdriver or something similar. Use only bulbs of the same type (for details, see the technical data in the following manual). [. . . ]