User manual HOTPOINT HNP 6.5S CD X/HA

[. . . ] cooktop 55 cm if the hood is installed over an • L’inosservanza delle norme di pulizia electric cooktop. Della cappa e della sostituzione e pulizia If the installation instruction manual for dei filtri comporta rischi di incendi. The gas cooking appliance specifies a greater distance, this measurement • Non utilizzare o lasciare la cappa priva should be taken into account. di lampade correttamente montate per possibile rischio di scossa elettrica. [. . . ] Air exhaust (for ducted units) Connect the hood to a duct and wall exhaust hole of a diameter equal to that of the air outlet flange. Using a smaller diameter tube and exhaust hole reduces the extraction capacity of the hood and also increases its running noise. The manufacturer is not liable for any consequences of doing so. Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. The duct must be made of regulatory material. Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, chimneys, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. T3 Speed 2 Pressing the button sets the hood to speed 2. T4 Speed 3 Pressing the button sets the hood to speed 3. t5 Lights ON/OFF * Only available in certain models 36 Models with soft button keypad and display HNP 6. 5S CD X/HA HPS 60 IX/HA B To reset the filter counter: Hold down T4 for three seconds while the hood is on. If both filter warnings are active at the same time, you must reset each separately. The first sequence resets the grease filter, while the second sequence resets the odour filter. Configuring the hood To set the operating mode of the hood, hold down T4 for 6 seconds. After a long beep, the type of installation displays: Ducted (square at bottom left flashing). GB T1 T2 T3 T4 T5 T6 1 Motor ON/OFF Press the button with the hood off to set speed 1. Pressing the button while the hood is in operation turns it OFF. T2 Speed Pressing the button returns the hood to the previous speed. [. . . ] The bar at the top right flashes to indicate that the odour filter is saturated. If both bars are flashing, then both filters are saturated. You must then clean/replace the grease filter (A) or odour filter (B) or both, accordingly (see “Maintenance and care”). The latter only applies to the filter version. [. . . ]