User manual HOTPOINT HNP 9.8 AB X/HA

[. . . ] € The cooker hood comes with anchor plugs which are suitable for use with most walls/ceilings. However, you must contact a qualified technician to check the suitability of the materials in relation to the type of wall/ ceiling, which must be strong enough to support the weight of the unit. Do not hook the unit up to its electrical power supply until the installation has been completed. € Before cleaning or servicing the unit, disconnect it from the mains by pulling the power plug or disconnecting the main circuit breaker. [. . . ] The manufacturer is not liable for any consequences of doing so. Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. The duct must be made of regulatory material. Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, chimneys, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. T3 Speed + Pressing the button returns the hood to the next speed. T4 Booster Pressing this button sets the hood to high speed; the letter "b" flashes slowly on the display. After 5 minutes, the hood returns to its previous speed; this can also be done while booster mode is on by pressing either speed button (T2 or T3). T1 Motor reset Press the button with the hood off to set speed 1. Pressing the button while the hood is in operation turns it OFF. T2 Speed 1 Pressing the button sets the hood to speed 1. T3 Speed 2 Pressing the button sets the hood to speed 2. * Only available in certain models 36 T5 Timer Pressing this button delays the hood turning off automatically by 5 minutes. The timer counts down on the display in minutes. The timer can only be set for manual speeds, not for booster mode. T6 Lights ON/OFF Grease/odour filter warnings The bar at the top left flashes to indicate that the grease filter is saturated. [. . . ] The first sequence resets the grease filter, while the second sequence resets the odour filter. Configuring the hood To set the operating mode of the hood, hold down T4 for 6 seconds while the product is off. After a long beep, the type of installation displays: Ducted (square at bottom left flashing). filter (square at bottom right flashing). [. . . ]