User manual HOTPOINT HS B10 BDB

[. . . ] Before you begin using the appliance, it is important that you thoroughly read these instructions and carefully keep them for further reference. GENERAL SAFETY RULES The safety features of your upright vacuum cleaner comply with the technical specifications and regulations in force. Do not use the appliance for any use other than its intended use. Any improper use could cause damage to persons and/or property. [. . . ] The Eco function (if available) allows to save 30% energy, compared with the consumption relative to max suction power, ensuring at the same time cleaning efficacy. We recommend using a low suction power on delicate surfaces to avoid any damage (e. To switch off the appliance rotate the switch-on/ power electronic control to the Off position. Unplug it from the electrical outlet and rewind the cord around the lower (17) and upper (16) supports. Park the upright vacuum cleaner in a vertical position or secure it to a wall using the special hole for wall support (15). An ordinary wall plug will be enough to secure the upright vacuum cleaner to the a bag clogged with dust/powder particles reduce the motor's suction power and can even damage it. Make sure the appliance is disconnected from the electrical outlet. Press the dust-compartment opening button (10) to open the dust compartment lid (8). Remove the dust bag by lightly pressing the dust bag support (23). Dispose of the dust bag in compliance with all local regulations on waste disposal. Fit a new dust bag to the intake valve (22), making sure it locks into the dust bag support. Let it dry at room temperature until all its parts are thoroughly dry. Re-place the HEPA filter (19), paying attention to the positions of the notches. Close the dust compartment lid until it clicks into place. Replacing the dust bag (D) We recommend always using HotpointAriston's original dust bags, because their special fabric allows optimum air filtration, maximum dust/powder retention, high performances and a long motor life. We recommend replacing the bag when the full-bag red indicator lights up. In any case change it at least once a year to be always sure of the best efficiency of your appliance. The pores of 15 en it Cleaning the washable bag (F) We recommend cleaning the washable bag when the full-bag red indicator lights up. In any case change it at least each 4 months to be always sure of the best efficiency of your appliance. Make sure the appliance is disconnected from the electrical outlet. Press the dust-compartment opening button (10) to open the dust compartment lid (8). Remove the dust bag by lightly pressing the dust bag support (23). [. . . ] Brush for hard floor with crevices (H) The brush (1) is designed for cleaning of hard floors on a daily basis, especially with crevices, but it can be used also for hard floors. 16 en it COMMISSION DELEGATED REGULATION (EU) NO 665/2013 Brand Model Energy Efficiency class Annual energy consumption in kWh/ year, rounded to one decimal place (1) Carpet cleaning performance class Hard floor cleaning performance class Dust re-emission class Sound power level in db(A) Rated input power in W Hotpoint-Ariston HS B10 BDB C 37 D A B 79 1000 Hotpoint-Ariston HS B10 BEB C 37 D A G 79 1000 Hotpoint-Ariston HS B10 BAB C 37 D A B 79 1000 (1) Indicative annual energy consumption (kWh per year), based on 50 cleaning tasks. Actual annual energy consumption will depend on how the appliance is used. Vacuum cleaner tested for use on both hard surface and on carpet (general purpose) and verified on the basis of the European standard: • EN 60312-1:2013, EN 60312-2:2013 for performance and energy consumption, • EN 60335-1:2012, EN 60335-2-2:2010 + A11: 2012, for the safety and the suction power, • EN 60704-2-1:2000 for the noise Information pursuant to EU Regulation 666/2013. [. . . ]