User manual HOTPOINT IC 644 CRFH

[. . . ] ақша Operating Instructions HOB Contents Operating Instructions, 1 WARNING, 2 Description of the appliance-Control Panel, 3 Installation, 5 Start-up and use, 7 Precautions and tips, 11 Care and maintenance, 12 Technical description of the models, 12 Русский Пайдалану нұсқаулығы ПЛИТА Маз € WARNING: The appliance and its accessible parts become hot during use. € Care should be taken to avoid touching heating elements. € Children less than 8 years of age shall be kept away unless continuously supervised. € This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] The indicator light directly by pressing the above the button will illuminate. This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. The booster stops automatically after 4 minutes. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). For further information, please refer to the Technical description of the models. Booster Switching off the cooking zones To switch off a cooking zone, select it using the corresponding selector button - + • Press the button: the power of the cooking zone will progressively decrease until it is switched off. - and: Programming the cooking duration !If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. €Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. and buttons simultaneously • Press and hold the for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. At step 2, press the button: the duration decreases progressively until it reaches 0 and switches off. The programme resets and the display exits programming mode. + - - Timer The hob must be switched on. The timer can be used to set a duration up to 99 minutes. Press the programming button until the timer . Buttons and press the button; • The display will show the text DE and MO and the hob will be switched off. € When the hob is switched on again it will be set to the “demo” mode. To exit this mode, follow the procedure described above. [. . . ] € Once it is clean, the hob may be treated with a special protective maintenance product: the invisible film left by this product protects the surface from drips during cooking. This maintenance task should be carried out while the appliance is warm (not hot) or cold. € Always remember to rinse the appliance well with clean water and dry it thoroughly: residues can become encrusted during subsequent cooking processes. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. [. . . ]