User manual HOTPOINT IKIS 630 LDF & IKIS 630 LD F,MV

[. . . ] Eu YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety messages, to be read and always observed. This is the danger symbol, regarding safety, warning of potential risks to users and others. All safety messages will be preceded by the danger symbol and the following words: DANGER WARNING Indicates a hazardous situation which, if not avoided, will result in serious injury. Indicates a hazardous situation which, if not avoided, could cause serious injury. [. . . ] The power cable must be long enough to allow the hob to be removed from the worktop. Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home. wARNING - - blue/grey black/brown yellow/green 1. Remove the terminal cover (A) by unscrewing the screw and insert the cover into the hinge (B) of the terminal. Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal. Secure the power cable with the cable clamp. Close the cover (C) and screw on the terminal with the screw removed. For each connection to the network, the hob automatically checks for a few seconds. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch off. If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down. If within 10 seconds of switching on, no function is selected, the hob switches off automatically. It is possible to select the required power level, from min. To increase the power level, push the “+” button. To decrease the power level push the “-” button. Deactivation of cooking zones To switch off the cooking zone, press the corresponding “+” and “-” button for more than 3 seconds. 9 , or booster “P” if available. Control panel lock This function locks the controls to prevent accidental activation of the hob. To activate the control panel lock, switch the hob on and press the Lock function button for three seconds; an acoustic signal and a luminous indicator near the padlock symbol signal activation. The control panel is locked except for the switching off function. To deactivate the control lock, repeat the activation procedure. The luminous dot goes off and the hob is active again. [. . . ] - Theappliancehasbeen used fornormal domesticpurposes only. - The appliance has not been altered, serviced, maintained, dismantled, or otherwiseinterferedwith by any personnot authorisedby us. - Any repair work must be undertaken by us or our appointed agent. - Any parts removed during repair work or any appliance that is replaced become our property. [. . . ]