User manual HOTPOINT KBH 6014 D IX/ 1

[. . . ] €¢ The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in compliance with regulations on electrical safety. Always ensure that this vital safety measure has been taken. If you have any doubts, call in a qualified technician to check the electrical system thoroughly. €¢ The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. [. . . ] During the first few hours of use, you may detect a smell of rubber, which will disappear quickly. 20 Installation and fastening The following instructions are intended for a qualified fitter to guide him/her along the installation, adjustment and technical maintenance procedures as correctly as possible and in full compliance with the applicable norms in force. Important : unplug the hob before all operations. Fastening Very important: It is vital that you ensure the glass ceramic hob is built into a perfectly flat supporting surface. Deformations due to improper fastening could alter the characteristics of the hob and compromise its performance. Installation • This hob can be built into a worktop simply by cutting out the corresponding slot. €¢ The worktop must be made with a material designed to withstand a temperature of approximately 100°C. €¢ The hob must be positioned at a minimum distance of 40 mm from the back wall and 600 mm from any other vertical surfaces, in order to allow adequate ventilation and to prevent the surfaces around the appliance from overheating. The fastening springs are fastened by screws (see diagram). It is vital that these screws be kept accessible at all times. Insert the hob into the cut-out slot, applying pressure all along the perimeter of the hob frame so that the latter adheres fully to the worktop. REAR SPRING ASSEMBLY 590 574 FRONT OF HOB 4 50 KITCHEN WORKTOP 39 30 56 0+ /- 1 49 /0+ 1 56 0+ /- 1 49 0+ /- 1 10 mm Distance to keep between the cut-out slot and the cabinet HOB FROM BELOW 21 40 52 0 39 Technical characteristics Connecting the hob to the oven This appliance can only work if it has been connected to a specific oven, listed on the sheet included in the documents pouch. KBH 6014/1 - KBH 6014 D BUILT-IN CERAMIC HOBS KBH 6004/1 - KBH 6000/1 BUILT-IN CERAMIC HOBS BLUE WHITE RED YELLOW BLUE GREEN WHITE RED YELLOW GREEN OVEN OVEN KBH 6034 DO - KBH 6024 DO - KBH 6024 DO/1 BUILT-IN CERAMIC HOBS This appliance conforms with the following European Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC of 03/05/89 (Electromagnetic compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments; - 2002/96/EC The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. BLUE WHITE RED YELLOW GREEN OVEN 22 Cooking zone description and use Radiant zones This type of burner consists of several coils that guarantee the even distribution of heat over the bottom of the pan and ensure the success of all cooking on low heat: simmering, sauces or reheating. • The glass ceramic hob is resistant to thermal and mechanical shocks. As long as the temperature of the cooking zones remains above 60°C, even after use, the residual heat indicators stay on to prevent the risk of burns. KBH 6034 DO - KBH 6024 DO - KBH 6014 D KBH 6014/1 - KBH 6024 DO/1 Power 1 2/3 4/5 6/7 8/9 10/11 12 Type of dish Melted butter or chocolate Reheating liquids Preparation of creams and sauces Cooking stews, blanquette, desserts Cooking pasta and rice Sealing meat, fish, omelettes Fried food The control knobs These are situated on the oven control panel and allow for the continuous control of the power setting of each cooking zone (from 1 to 12 or from 1 to 6). [. . . ] In this case, unplug the appliance immediately and contact an authorised after-sales service centre to have it repaired. Before proceeding with maintenance operations, check that all the cooking zones are turned off and have cooled down completely. Stainless steel frame (only on some models) Stainless steel can stain as an effect of enduring contact with limescale in water or as an effect of highly aggressive detergents (containing phosphorus). We recommend you rinse and dry it thoroughly after maintenance. [. . . ]