User manual HOTPOINT KBT 6114 D

[. . . ] €¢ Before using the appliance, read the instructions in the owner’s manual carefully since it contains all the instructions you require to ensure safe installation, use and maintenance. Keep this owner’s manual in a safe place for future reference. €¢ When you have removed the packing, check whether the appliance is intact. If you have any doubts, contact a qualified professional before using the appliance. [. . . ] €¢ Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. €¢ Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the appliance, indicated on the appliance data plate. if in doubt , contact a qualified professional. Disconnect the appliance from the electricity supply before all operations. Connect your hob to the electrical system by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed. if in doubt , contact a qualified professional. The cable provided is not suitable for the following types of installation. Use a suitable supply cable, H05RR-F or higher, with the right dimensions (cable section: 2. To open the terminal board, insert a screwdriver into the side tabs of the cover and open it (see Terminal board picture). Loosen the cable clamp screw and the terminal board screws according to the type of connection required and position the connection supports as shown in the following table and diagrams. Position the wires according to the following table and diagrams and connect the appliance by tightening all the screws for the springs as much as possible. Voltage and mains frequency 400V 3-N ~ ı 50 Hz Electrical connections Terminal board Three-phase 400 Single-phase connection The hob is equipped with a preconnected electricity supply cable, which is designed for single-phase connection. Secure the power supply cable by fastening the cable clamp screw, then put the cover back on. 2 4 1 3 5 Three-phase 400 Phase U-bolt Phase Phase Neutral Earth connection support 31 This appliance conforms with the following European Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC of 03/05/89 (Electromagnetic compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments; - 2002/96/EC Warning: If the hob is fitted above a built-in oven, the hob and the oven must be connected to the mains separately for safety reasons and to simplify operations when it is necessary to pull the oven out for some reason. The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. Halogen zones are appreciated for their properties, which are similar to those of gas burners: rapid reaction to settings, instant display of the power level. Radiant zones This type of burner consists of several coils that guarantee the even distribution of heat over the bottom of the pan and ensure the success of all cooking on low heat: simmering, sauces or reheating. A specific key controls the extension of the zones (concentric or oval). As long as the temperature of the cooking zones remains above 60°C, even after use, the residual heat indicators stay on(the power indicator displays H) to prevent the risk of burns. [. . . ] For excellent results, use a special stainless steel wool pad for vitroceramic glass cleaning soaked in soapy water. €¢ When the hob is clean, you can apply a special product for the care and protection of the same: this type of product leaves an invisible film on the surface of the hob to protect the same against any spills and boiled-over food. It is best if you do this when the hob is lukewarm or cold. €¢ Make sure you always rinse the hob with clean water and dry it thoroughly: otherwise the cleaning products could become encrusted onto the hob during subsequent cooking. [. . . ]