User manual HOTPOINT KBTN 6313 I T

[. . . ] 10 Operating Instructions HOB Contents IT Italiano, 1 GB GB English, 11 FR Français, 21 Installation, 12-14 Positioning Connecting the hob Disposal GB NL ES PT Portuges, 51 Description of the appliance, 15-16 Control panel Cooking zone description Turning on the hob Turning off the hob The booster Nederlands, 31 Espanol, 41 Start-up and use, 17 DE Deutsch, 61 The safety devices, 18 KBTN 6313 IT/HA KBTN 6313 IT CL/HA Pan recognition What cookware to use Acoustic signal Safety cut out Overheating protection device Precautions and tips, 19 Practical advice on using the appliance General safety Care and maintenance, 20 Switching the appliance off Cleaning the appliance Disassembling the hob Installation GB !Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. Please keep these operating instructions for future reference. [. . . ] To change the power level setting or stop cooking, the controls have to be unlocked: press the key, the indicator light turns off and the controls are unlocked . pOWER (from 0 to 9) and RESIDUAL HEAT indicators ZONE SELECTION indicator COOKING ZONE SELECTOR Keys COOKING ZONE SELECTOR Keys 0 Booster POWER (from 0 to 9) and RESIDUAL HEAT indicators BOOSTER * Key POWER DECREASE Key POWER INCREASE Key ON/OFF Key Controls LOCK Key LOCK indicator light * Only available on certain models. Cooking time programming You may programme all the cooking zones simultaneously for a maximum cooking time of 99 minutes. Proceed as follows: • select the cooking zone by pressing the corresponding control key, • set the desired heating power using the “+” and “” keys, • press the programming key , • set the desired cooking time using the “+” and “-” keys, • confirm the programming by pressing the key again. The end of programmed cooking is signalled by a beep (one minute long) and the cooking zone is turned off. Triple induction plate operation The operation of this plate depends mainly on the diameter of the pans which are used during cooking: • if the pan’s diameter falls within the first markedoff area, it will be possible to switch on the individual internal plate. In this case, the booster does not work and the power output is 1800W; • if the diameter of the pan falls between the first and second marked-off areas, the maximum power output increases to 2400W (up to 3000W with the Booster enabled); • if the diameter of the pan exceeds the second area and falls between the second and third ones, the power output of the plate may reach 3000W (up to 4000W with the Booster enabled). Therefore, the Booster function may be enabled only in the last two cases indicated, with an energy absorption of between 3kW and 4kW, depending on the diameter of the pan; that is, when the size of the pan exceeds the diameter of the first area. The booster function is not enabled if you use only the smallest central cooking zone (1800W). GB Turning on the hob Press key for 3 seconds to turn the hob on. • or press the “-” key: the heating power drops progressively until the zone eventually turns off. Press the key; the appliance has been turned off. If you have locked the hob controls (see paragraph below), the same will still be locked when you turn the hob back on. Unlock the controls in order to operate the cooking zones. Turning off the hob To speed up the rise in temperature of the cooking zones (see cooking zone table on the previous page), press the key. The booster function comes to an automatic stop after 4 minutes. When the booster function is on, certain cooking zones (see the cooking zone table on the previous page) are limited to a maximum power of 600W. Booster The booster 17 The safety devices GB Pan recognition Acoustic signal Each induction cooking zone is fitted with a pan recognition device. The cooking zone only provides heat in the presence of a pan which is suitable for the cooking zone. A blinking pan recognition indicator could signal: • that the pan is made of unsuitable material, which is not ferromagnetic, • that the diameter of the pan is too small, • that the pan has been removed. Always match the diameter of the pan with that of the cooking zones. The following warnings are provided for safety reasons and must be read carefully. [. . . ] In this respect, we can only guarantee our own product conformity. Please consult the pacemaker manufacturer or your doctor concerning its conformity or any possible incompatibility. • Do not let children play with the appliance. GB 19 Care and maintenance GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. [. . . ]