User manual HOTPOINT KC 62 DO IX

[. . . ] Make sure this basic safety requirement has been complied with. If in doubt, have it checked by a qualified technician. No liability for damage will be accepted by the manufacturer because of defective earthing. [. . . ] the vitreous china hob is resistant to temperature fluctuations and shockproof. When you turn on the cooking surface always place a pot on the surface immediately as it will otherwise overheat very quickly and possibly damage the heating elements. The glass sealant utilised may leave traces of grease on the glass. Remember to wipe these away with a normal non abrasive detergent before you turn on the appliance. During the first few hours of use there may be a smell of rubber which will disappear very quickly. 12 13 14 15 16 17 18 19 20 21 22 6 Installation The cooktop has a type Y protection against overheating. Therefore, the appliance may be installed next to cabinets which are higher than the surface of the cooktop. The recessed vitreous china hob may be installed on tops of 600 mm or more, provided these are treated with materials resistant to temperatures of up to 100°C. The dimensions and position of the hole are shown in fig. Remember that incorrect installation may lead to overheating of the adjacent surfaces. Keep the hob at least 40 mm from the back wall or other vertical surfaces to ensure proper ventilation and prevent overheating of the adjacent surfaces. Ensure that the gasket fits properly under the moulding of the top. The gasket must fit properly into the corners and around the hob so as to create an efficient seal between the top and the hob to prevent leaks into the cabinet below. 575 -2 Important: The surface on which the hob is fitted must be perfectly flat. Warping due to improper installation may alter the characteristics of the top and its performance. A A 30 A A Fixing position Hook position for H = 40 and 30 mm Electric connection KC 60 BUILT-IN CERAMIC HOBS 505 39 49 555 0 +0 560 +0 -2 572 595 558 min 54 3 601 min WHITE RED YELLOW BLUE GREEN in m 23 5 54 50 m in OVEN 595 20 Electric connection KC 62 BUILT-IN CERAMIC HOBS Mounting the hob • Fix the 4 hooks supplied with the hob into the 4 slots; • Connect the connection cable to the terminal board of the cooker, as shown in the diagram of Fig. ; • Fit the hob in the oven pressing the moulding firmly into place so that the hob is well attached to the Top. BLUE WHITE RED YELLOW GREEN OVEN 7 40 Description The hobs have been provided with radiant electric heaters. [. . . ] First remove all spilt food and fat with a window scrape, preferably the razor blade type or, failing that, the fixed blade razor edge type (not supplied). Clean the hob while it is still warm to the touch with a suitable cleaner and paper towel. Rinse it and wipe it dry with a clean cloth. [. . . ]